1. Home
  2. How To Guides
  3. How To Replace the Swivel Assembly on a Polaris ATV Suction Cleaner

How To Replace the Swivel Assembly on a Polaris ATV Suction Cleaner

WRITTEN BY: 

  0 out of 5 stars on 0 ratings
(Click on a star to add your rating)

If your Polaris ATV Suction Cleaner is pulling to one side or is not covering the pool floor, check that the Hose Swivel at the rear of the Cleaner moves freely. If not, you may have to replace it. This guide shows you how to replace your Polaris ATV Suction Cleaner Swivel Assembly.



Comments

Email

Print

Steps

Things You'll Need

Polaris ATV Suction Cleaner Swivel Assembly

Step by Step

Top

Step 1

ORDER PARTS - The first step is to order the parts you will need. The only part required for this procedure is the Polaris ATV Suction Cleaner SWIVEL ASSEMBLY.

Step 2

REMOVE TOP HOUSING - The Top Housing is held on by two screws. With a Philips head screwdriver remove the two screws.

Step 3

LIFT TOP HOUSING - Lift the Top Housing off of the top of the Polaris ATV Suction Cleaner.

Step 4

REMOVE LOWER HOUSING - Turn the Cleaner over on its back. The Lower Housing is held on with three screws. Remove these screws with a Phillips head screwdriver.

Step 5

LIFT LOWER HOUSING - Lift the Lower Housing off of the Cleaner to gain full access to the Swivel Assembly.

Step 6

REMOVE SWIVEL ASSEMBLY - Unscrew the Swivel Assembly off of the Power Module.

Step 7

REPLACE SWIVEL ASSEMBLY - Screw the new Swivel Assembly onto the Power Module. Verify that the Swivel moves freely.

Step 8

REPLACE THE LOWER HOUSING - Place the Lower Housing on the bottom of the Cleaner and secure it with the three screws.

Step 9

REPLACE THE TOP HOUSING - Place the Top Housing on top of the Cleaner and secure it with the two screws.

Step 10

REPLACEMENT IS COMPLETE - Your Polaris ATV Suction Cleaner is ready to go

Comments

Top
Add a Comment

Be the first to add a comment