$101.49

Qty:

Details

Top

Part # NFC1638

Alternate Part #'s 171751443, 19909, 2301600, 244-0100, C-7419, C7419, FC-1638, FC1638, FC1670, PMT100, R173551, XLS-755, 17-175-1443, APCC7278, PLEPMT100

Product Description

HIGH QUALITY POOL & SPA REPLACEMENT CARTRIDGES

  • Our generic replacement cartridges are less expensive than the original manufacturers' brands yet still meet the same high quality standards.  The key components of a cartridge - filter media, core, and end cap - are all designed for maximum water flow and cartridge life.
  • The filter media is point bonded polyester with even fiber distribution which results in an even dirt load and increased water flow.  
  • The Sharp & Uniform pleated media provides filtration area (square footage) that meets or exceeds the original manufacturers' specifications.  
  • An open core design provides sturdy support for the media without restricting flow.  Increased flow rates result in less wear on the pump and reduced energy usage.  
  • Anti-microbial end caps inhibit the growth of bacteria, mold and mildew while supporting the core and media.
  • Banded Pleats maximize flow during operation, and help to reduce the frequency of cleaning.  Banded pleats also make the cartridge easier to clean.
  • We carry thousands of generic cartridges to replace all of the most popular OEM brands such as Sta-Rite, Pentair / Pac Fab, Hayward, Purex, American Products, Jacuzzi,  Hot Springs, Coleman, and more.
Top End Cap Top End Cap
Bottom End Cap Bottom End Cap

Product Specifications

Manufacturer:
Advantage/Sonfarrel
Diameter:
7 - 1/4 in.
Length:
21 - 9/16 in.
Top Style:
Open
Top Inside Diameter:
2-15/16"
Bottom Style:
Open
Bottom Inside Diameter:
2-15/16"
Filtration Area:
100 sq. ft.
Media Weight:
4 oz.
OEM #:
244-0100
Unicel #:
C-7419
Filbur #:
FC-1638
Pleatco #:
PMT100
Generic:
Yes
Top
Difficulty

Est. Repair Time

Less than 1 hr

Tools Needed

Both hands

Filter cartridge was very old and had broken apart. Thanks to INYOPools for having this product in stock.

Written on 8/26/2019 by Guest

1. Remove old filter cartridge from pump filter housing.
2. Remove plastic wrapping from new filter.
3. Insert new filter into filter housing.
4. Before inserting however, wet both ends with water or use a light amount of silicone to lubricate the ends so that they will slide into bottom and top housings (lid).
5. Place the lid on top of the filter and wiggle the lid while pushing it down.
The cap will need to go down far enough so that the lid securing ring will screw the lid down tight.
6. You’re done when you see the cartridge lid securing ring screwed as far as it can safely go.
7. You can start the pump and begin vacuuming!

Were these instructions helpful? 
 

Top

Review Summary

 (Average 0  out of 5 stars)
0 Rating
5 star:
 
(0)
4 star:
 
(0)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)