Part # 17-150-1544
Manufacturer Code CX900DA
Cone Kit, Star Clear Plus - CX900DA
how do I replace these without braking the rest of it
Reply
The cone is secured to the center rod with an e-ring. These are difficult to remove without buying a special set of pliers that attach to holes in the e-ring and spread the ring open to remove it.
Reply
How does the e-ring and washers go on?
Reply
The easiest way I have found to remove the e-ring is to get a large flat-head screwdriver. You place it in the curved side and turn. This should pop the e-ring loose. From there the handle will slid out the top. You can then replace the o-rings and washers. To put the e-ring back on takes a little more patience. Carefully place the e-ring in the slot, then with the flat-head screwdriver try to leverage it back into place.
Reply
Do you have directions on how to install the cone guide. I assume the earing goes on the rod and then the cone guide slides over it. Detailed instructions would be helpful...thanks
Reply
Hello- Unfortunately, we do not have any installation instructions for this part. From personal experience, I can tell you that the e-ring goes on the inside of the lid to hold the knob in place the cone simply slides over the rod.
Reply
May I return the Hayward star clear plus filter washer - o ring and clip (Cone kit parts) if they don't fit properly. Local pool stores don't have these parts and did not show interest in solving my Locking Knob replacement items. James
Reply
Hello James. Yes, the Hayward Pool Products Cone Kit for the Star Clear Plus may be returned. Attached please find a copy of the INYO Pools Return Policy. Return Policy
Reply
Less than 1 hr
Screwdriver
3 0
1. Remove cone and e-ring. (pop off e-ring with a screwdriver)
2. Remove locking knob and o-ring and washer. (knob pulls out from the top)
3. Slide new washer on locking knob, then install new o-ring, re-install knob.
4. From inside filter housing place second new washer on knob, then take e-ring and line it up by hand in the groove, then with a large flat blade screwdriver push the e-ring into the groove from the center of the e-ring, replace new cone and your done.
The Most Recent Reviews
(5 out of 5 stars) Filter washer replacement
Reviewed By: Inyo Customer ()
Perfect set made repair easy!
Was this review helpful to you?
(5 out of 5 stars)
Reviewed By: Inyo Customer ()
Second time replacing this, cheaper than a whole new filter
Was this review helpful to you?
(5 out of 5 stars) No More Leaks
Reviewed By: Inyo Customer ()
So far so good, no more leaks and the water pressure is back to normal. Been installed now for 3 days.
Was this review helpful to you?
(5 out of 5 stars) Great to have filter top working correctly again
Reviewed By: Inyo Customer ()
Great to have filter top working correctly again, OEM parts fit perfectly, easy to install, and now top removes easy as it's supposed to.
Was this review helpful to you?