By Carvin


Details

Top

Part # 94028891

Product Description

Patented air-cooled heat sink allows pump to run dry without damage to shaft seal. UNCONDITIONAL TWO-YEAR WARRANTY AGAINST SEAL FAILURE.

Diffuser/casefit plus "pry" tabs allow for simple assembly or disassembly

Ring-Lok™ strainerallows "tool free" access to the strainer basket.

Internal ribsin large strainer basket assure flow even when filled with leaves and debris.

High efficiency impeller/diffuserfor increased performance and priming capability.

Self priminghydraulic design provides suction lift up to 10' (3 m) above water level.

Floating eyeseal between the closed impeller and diffuser maximizes pump efficiency for best flow and pressure.

56 Frame mount square-flange dual-voltage motorsare standard on all units.

2" (51 mm) FNPT plumbing connections.

One piece casemolded from glass-reinforced,corrosion-resistant thermoplastic with two convenient drain plugs for winterizing.

Maximum water temperature 104 °F (40 °C).

Click here for more Jacuzzi Pumps

Product Specifications

HP:
1 HP
Speed:
Single
Volts:
115/230 V
Amps:
12.4/6.2
Port Size:
2 in.
Service Factor:
1
Top

?     Asked on 3/17/2015by Inyo Visitor

Can this run on 110v?
 Reply

A  Answered on 3/18/2015 by InyoPools Product Specialist Robert M.

This is a dual voltage motor. It will run on 115 or 230 volts.
 Reply


?     Asked on 6/12/2015by Dan

Will this pump work if my GPM is 80 gallons?
 Reply

A  Answered on 6/13/2015 by InyoPools Product Specialist Patrick P.

Hi Dan, If you need 80 gallons per minute then I would suggest the 1-1/2 HP Jacuzzi Cygnet Pump or if your budget can afford it then the 1-1/2 HP Jacuzzi Magnum Pump. The Magnum in general is "beefier" pump which has quite a bit larger basket to handle more debris, includes unions and has an overall larger pumping capacity.
 Reply


?     Asked on 6/13/2016by Inyo Visitor

are there any unions available fo this pump? will it replace an older hayward max-flo 1 hp? thanks
 Reply

A  Answered on 6/14/2016 by InyoPools Product Specialist Patrick P.

For the Jacuzzi Cygnet you would require two of these 2" Male x 2" Slip Unions this pump will replace the Hayward Max Flow from a water output standpoint. The port locations on the Cygnet are different than the Max-Flo so you will have some re-plumbing.
 Reply


?     Asked on 6/26/2016by mike

hi, i was wondering if there is a pump curve for this model? i am replacing an old hayward max flo 1 hp unit. it looks like this draws less amps. is this a discontinued model? thanks
 Reply

A  Answered on 7/2/2016 by InyoPools Product Specialist Lennox H.

Hi Mike, Click link > Jacuzzi Cygnet Brochure to view the performance curve.
 Reply


Top

Review Summary

 (Average 5  out of 5 stars)
2 Rating
5 star:
 
(2)
4 star:
 
(0)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)

The Most Helpful Review


The Most Recent Reviews