Part # 520272
Dimensions 8.25" L x 2.25" W x 1.25" D
Air/Water Temperature Sensor - White or Black - 520272 for the Compool, EasyTouch, IntelliTouch, SunTouch
The diameter of this sensor is 1/4" diameter with 20' of 2 conductor bare wire.
On Pentair 520272 Temperature Sensor when do I know when is defective and if is, do I need to replace both, the solar and the water sensors?
Reply
Hi. You can test ohm resistance or compare the readings from what the sensor is registering to the actual temp.
Reply
The 521590 Pentair Solar touch is not working properly. The system status light is green (Normal) but I can not adjust the pool temperature. I feel that I need to replace the temperature sensors, the water sensor is connected to a pipe and the roof solar sensor is not connected to anything just laying there on the roof. Do I need to replaced the unit or both sensors?
Reply
Hi. If you're unable to increase or decrease the temperature, the sensors may not be the issue. Since the system does not detect an issue with the sensors you can manually test the sensors using the info on page 24 of the SolarTouch Solar System Installation/User Manual. You can replace both sensors if they're bad.
Reply
Have a GVA-24 Valve Actuator and the "heat light" does not come on in the control panel. The actuator works but it does not change rotation when you move the thermostat all the way up or down. Is this a internal problem or is it a roof sensor?
Reply
Hello, Unfortunately, we are not certified Pentair reps to properly troubleshoot this unit for you. We recommend contacting the manufacturer with that question. You can reach them at 1-800-831-7133
Reply
$108.75
$175.42
$301.49
The Most Helpful Review
2 0
(5 out of 5 stars) Exact match
Reviewed By: Pbod from Highland Village, TX ()
Pros: It works
Cons: Proper drill size?
Exact replacement for my Pentair EasyTouch system. Pentair does not state the drill size in the instructions. It's assumed for replacement only in an existing hole. In my case, I was moving the sensor. A 1/4" drill is too small and 5/16" is a hair too big, but it still sealed fine. It would be nice to know in the instruction what size drill Pentair recommends for a new install.
Was this review helpful to you?
The Most Recent Reviews
(5 out of 5 stars) Quality part.
Reviewed By: John I. ()
This sensor installed quickly. Make sure you de-energize the control panel prior to installation. There's plenty of wire length to position the sensor in a shaded area out of the direct sunlight.
Was this review helpful to you?