By Pentair Pool Products
Part # 150119
Tagelus Multiport Valve Union Kit for 1 1/2" Top Mount Valve Flanged (262506)
Hi there,
I bought the PL0700 replacement valve for my sand filter and looking to purchase this rather expensive union kit. Does the kit come with detailed instructions so I don't make an expensive mistake?
Reply
Hi Robert, unfortunately, this union kit does not come with instructions as no two plumbing arrangements are the same that will need to be connected to these unions. Ideally, these unions just thread to the valve and then the opposite ends of the unions will be slip glued to the plumbing you have at your pool system.
Reply
Hello. My pool assistant tells me I have a leak going through the WASTE section of my Pentair TA-100D sand filter. She says I need to replace the valve on the inside and that I can do it myself, but I need to purchase the part. Is this the part I need? Thank you.
Hi, Joel. To repair your valve, you can use the MPV 2" Tune Up Kit - APCK1069 (NO SPRING) or APCK1069S (WITH SPRING).
Reply
Do I need the kit with the spring or without? I have no clue what the difference, advantages or disadvantages might be...if any. Please advise.
Reply
Joel, Which kit you get will be base on the valve performance. If you do not have an issue pushing the valve handle down and it snapping back up, you can get the kit without the spring because yours is fine. If not, get the kit with the spring.
Reply
I’m needing to change out the sand in a Pentair Tagelus TA-100D sand filter (P/N 145240). I’m ordering the PacFab MPV 2” Tune Up Kit (No Spring) - APCK1069. But I need to install unions on the three 2”, Schedule 40 PVC lines entering and leaving the multi port valve (Model TM-22). Please specify the 2” union kit I need. Thanks.