Part # PL0156
Manufacturer Code 17-4980
Dimensions End Cap = Round, Length = 33 3/8", Outside Diameter = 7 7/8", Inside Diameter = 3 1/16"
PureLine Aftermarket Replacement Cartridge for Pac Fab® Mytilus FMY Filters
Is your pool water starting to look a little dull? Is your pressure gauge reading a higher PSI than normal? Are your pool jets a little less powerful? These are all signs that it is time to replace your pool filter cartridge. Replace your pool filter cartridge today and regain that crystal clear pool water and extend the life of your pool pump.
Typically for single cartridge pool filters we suggest replacing your cartridge every 6-12 months and for filters which take multiple cartridges, we suggest replacing your cartridges every 3 years.
This Cartridge is Commonly Used In
PureLine Cartridge Benefits
Not Your Cartridge?
Is this not your Cartridge? Don't worry, we carry thousands of Pool Filter Replacement Cartridges to replace all of the most popular OEM brands such as Sta-Rite®, Pentair® / Pac Fab®, Hayward®, Purex®, American Products®, Jacuzzi®, Hot Springs®, Coleman®, and more. Click here for more Pool Filter Replacement Cartridges
Disclaimer:
All manufacturers’ names, brand names, trademarks, images, symbols, descriptions, and part numbers are used herein for reference purposes only.
For my Mytilus FMY 150, I see you have both the -50 and -100 filters which I use today. However is the -150 filter compatible so that I can just use this single filter? And if so, what are the advantages/disadvantages of doing so?
THANKS
Reply
Hello Dan - The 150 cartridge can be used to replace the 100 and 50 cartridges. Originally, the single 150 cartridge was not available for the Mytilus. There are no disadvantages to using the single cartridge. The advantage is the cost. It is cheaper to buy the single 150 cartridge.
Reply
4 Pac Fab filters. model f, serial 01 filter area 420 square feet
Reply
Hi, Since you have a 420 Sq. Ft. Pac Fab Filter then most like you will need the PL0120 Clean & Clear Plus 420 Replacement Cartridges The PL0120 cartridges measure 26 1/16" Long x 7" Wide with a 3" Center Hole so I would double check those measurements against your current cartridges.
Reply
I have a Pac Fab Mytilus model M90 and need a cartridge filter. The part number I have is 17-4819 6sq. ft. What part should I purchase. The cartridges you have listed do not match any numbers. Thanks
Reply
Could you send us a few photos, showing the complete filter as well a close shot of the filter label and cartridge end cap? To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation.
Reply
Less than 1 hr
Socket Set
Less than 1 hr
None
1 0
Simple. Open butterfly release valve at top of cartridge assembly. Release collar clamp, then remove hood to Cartridge assembly. Unscrew plastic nut, then pull out existing filter. Replace with new filter. Reattach collar, then reattach the Cartridge cover. Turn pump on and allow air to bleed out. Then close Butterfly valve. Done
The Most Recent Reviews
(5 out of 5 stars) This is a very well made filter cartridge !
Reviewed By: Inyo Customer ()
Works great ! I bought this a little over 3 years ago. I have an indoor bromine pool so it doesn't get the abrasive dirt and misc particles that an outdoor pool would get, but the filter material is holding up great and still looks like new. The filter pump runs about five hours per day and I clean the filter every three or four months.
Was this review helpful to you?