$11.71
By Essex Group
Part # 5270-43
Manufacturer Code TB-1032-12
Motor Thru-Bolts4 sizes fit most A.O. Smith, Century, and General Electric pool pump motors. All bolts made from 302 stainless steel to resist corrosion
Are these the bolts for the Jandy stealth pump? I measured the bolts that I drilled out and they were about 11 1/2" including the hex end, but 10-32 and 2" threaded. I guess if its a little too long, I can gring it down a bit.
Reply
Hello, I would check with Jandy 800-822-7933 to see if they make specific ones to go with the stealth model, the 5270-43 will not be long enough for what you need if they are measuring 11 1/2".
Reply
i need a thru bolt for a sta rite motor, 2 h.p., model # MPRA6G-155L, that measures about 11 & 1/4 inches, don't know thread size. Also need a bearing, The one I need to replace is a NSK 6204 V. Already replaced the one at other end that was a 6203. Thank you, part #'s please
Reply
i have a centurion for pac-fab motor for my challenger pool pump, part#8-168787-02 1.5 hp, 1.47 sf. i am looking for thru-bolts (i measure 11 3/8) and bearings for this motor.
Reply
Brian- The bearings you will need are the Bearing, 203 (62032rs) (Single) and the Bearing, 304 Ntn-6304-ll (6304). As far as the thru bolts that is a part number 16285671, but we do not carry those.
Reply
