$299.59
I have had to install a new flow sensor in my salt system. The plastic fitting that is threaded into the pod is broken. Do I have to replace the pod also or can I buy this plastic fitting by itself. It is a Jandy aquapure Ei series 35plg. Thank you
Reply
Hi Bill, you should be fine with just the flow sensor listed on this page.
Reply
I understand that I have the right sensor but where the sensor screws into the pod was broken, I was able to get the plastic threaded bushing out but now I am left with no way to screw the sensor into the pod . My question is can I buy the fitting or must I buy the whole new pod cap? thank you
Reply
Hi Bill, unfortunately that fitting is not available by itself and is only available with the AquaPure Ei Pod Cap, so you would need to purchase the pod cap to get the fitting.
Reply
Patrick; does you company sell the pod cap for the Jandy Aquapure Ei series salt system ? I would like to buy one from someone.
Reply
Thank you Bill... you can click on this link to purchase the AquaPure Ei Pod Cap.
Reply
Do you have the plug that the flow switch plugs into at the SWG? It is mounted to the panel where the power comes into the SWG
Reply
The only parts available for the Aquapure Ei Power Pack are listed in the schematic shown here. I have reviewed the manual to see if there is any other parts that would be offered and could not find one. I have included the link to the manual, you may want to contact Zodiac at 1-800-822-7933 to see if they may be of more assistance. Please click here to view the link.
Reply
on the jandy control pack screen it says on test cell how do u test the cell?
Reply
Hi, Robert. The "Test Cell" message indicates that the electrode is dirty, scaled and/or worn. To resolve this you will need to clean the cell if it's dirty, or replace if the cell has been in operation for over 9,000 hours.
Reply
The Most Recent Reviews
(5 out of 5 stars) Jandy flow switch
Reviewed By: David B. ()
Easy to install
Was this review helpful to you?