PER THE MANUFACTURER: THIS ITEM IS NOT AVAILABLE FOR SALE ONLINE
Model # 99996133-USF
Warranty 24 Months
Alternate Part #'s 99996133USF, MAY-20-1114, MAY99996133-USF, MAY99996133USF
Discover an Exceptional Experience
All swim, no work. That's the life for you. Forget about scrubbing the floor and scooping out leaves and dirt. The Dolphin E10 robotic cleaner does it all for you, automatically. The Dolphin E10 leaves your pool floor clean and the pool water sparkling clean!
Effortless Operation
Crystal-Clear Cleaning Results
Peace of Mind
Frequently Purchased with Dolphin E10 Cleaner
Dolphin Universal Caddy 9996084-ASSY
Ultra Fine Filter Cartridge Assembly 9991460-ASSY
Does this pool cleaner have to be hooked up to the skimmer??? Or does it clean on its own?
Reply
Hi Phillip, No this pool cleaner does not get hooked up to the skimmer. It plugs into a standard 115V outlet, the power supply has a transformer so only 24V low voltage is going to the cleaner.
Reply
What about a 30’ round? Will it handle that?
Reply
You may run into issues where the normal pattern doesn't hit the farthest side. If that is the case, you could drop the cleaner in the spot that it missed and start it there.
Reply
Less than 1 hr
Screwdriver, level, drill screws, drill bits, driver bits
1 0
I bought the Maytronics Dolphin E10 Above Ground Robotic Pool Cleaner as it seemed to have a solid design and was attractive. I wanted to table top mount the control unit. After all, it isn't too bad to look at and I wanted to position it close to the back door of the house so that I could easily activate it if I saw the pool needed a little sprucing up. Upon reading the directions I discovered it needed to be mounted out of the rain and cannot directly get wet or be submersed in water. However, no mounting hardware was provided for wood, metal or concrete. I fan to Home Depot, purchased a small level, marker and several wood screws. The mounting hole spacing is approximately 4" on the back of the unit. I chose a spot under my deck near my CircuPool chlorine generator controller. I used the level and marker to draw a level line, then with a T-25 torx bit, I set the first screw on the level line. I measured 4" to the right and set the second screw. The unit was then easy to hang and mount. Keep in mind to do all of this while the unit is unplugged form AC power and the robotic cleaner cord is detached. Happy swimming!