I currently have a AO Smith 3 HP B131 motor (SF 1.15, Y56J) that started getting very noisy (despite impeller replacement).
Would this fit? And hopefully save me energy? My pool is a pond that isn't very big (maybe 10,000 gallon)?
Reply
Yes, this motor will fit and has matching specifications and a low-speed option which may save you energy.
Reply
I am looking for a heavier duty pump for my inground pool. It has a 1 hp A.O. Smith Round Flange Up Rate Motor UST1102. I have had to replace it three times in just over 5 years. It has not been due to improper installation. I changed all the seals as well. It is a sorry product. Would this motor due a better job. Due you have any suggestions.
Reply
Hello, Unfortunately, we do not have a heavy duty motor for the UST1102.
Reply
I have the 2Green 2 speed pump where the controller is randomly
shutting off. The motor is running fine, can I just replace the user interface?
Thanks
Hi, Rob. Unfortunately, the controller is not available as a separate part.
Reply
The display screen on my pool pump has all of the pixels lit and it is impossible to navigate any of the screens. This has rendered my pool pump useless. I have tried to adjust the contrast following the manual and this did not change anything. Can I replace the "brain" or the display and make the pump function again? Sorry the picture was taken during a Tropical Storm.
Hello, Unfortunately, you would have to replace the entire motor.
Reply
Turns out the contrast had adjusted somehow and after following the instructions online was able to increase the contrast and could read the display again.
Reply
Will this replace the 2 hp one speed motor on my Hayward SP3015X20AZ and what else would be required to make this work?
Reply
Hi there, No this motor would not work as a replacement for your Hayward SP3015X20AZ also it has been discontinued. If you wanted to stay with a Single Speed motor then you would go with this UST1202 Replacement Motor and if you wanted to go with a variable speed motor then you would get this 2.7 HP Variable Speed Motor if you went the variable speed motor then you would need to replace your impeller with this 2.5 HP Super II Impeller. In both cases you will also need this Hayward Super II Seal Kit. I hope that helps, all items are in stock ready to ship!
Reply
Hello,
I would like to upgrade to a two speed motor, 208/230 volts that is built in the USA, can you recommend one (current motor picture attached)? How much more would a variable speed motor be?
Regards,
Steve
Hi, Steve C. Your options are the STS1102RV1 (Dual-Speed) or the ECM16CU (Variable-Speed).
Reply
Is there a 2 speed motor that would work to upgrade my single speed motor And what all parts would be needed to complete the swap? I have Hayward SP3015X20AZ.
Hi Thomas to upgrade to 2 speed you would require this STS1152R Dual Speed Motor along with this STS Dual Speed Motor Switch You will also need this Hayward Super II Seal Kit when replacing your motor
Reply