What is the difference between a GLX-CELL-5, and a GLX-CELL-5W?
Reply
The GLX-CELL-5 cell comes with a 3 year manufacture warranty, where the GLX-CELL-5W, only comes with a 1 year manufacture warranty.
Reply
We have a AQ-RITE-20 (T-5) complete system purchased in 2008 and need a replacement T-5 cell- is this replacement cell compatible with this unit- specifically the board/software in the control panel from 2008?
Reply
Yes the t-cell 5 is compatible with your model system.
Reply
i have mineral springs MS-20 cell what cell replaces it. oh owners manual says MS-20 and MS-21 NOT SURE WHICH ONE I HAVE
Reply
Hi Sheryl, You would require the TCELL15 Salt Cell here.
Reply
I don't see GLX anywhere on our paperwork, but it says AQ-Trol-RJ. Turbo cell T-cell-5 GI-929004C PMRA Reg# 24583 and then 3E0806-2048870 24 VDC 5 A max. Can you help with waht cell we need? Thanks
Reply
Hi Rudy, this would be the correct replacement cell for your AQ-Trol-RJ. At one point this cell was labeled T-CELL-5 however Hayward recently changed the part # to GLXCELL5.
Reply
How do I clean cell?
Reply
Hello Mark, lucky for you we have a "How To" guide on this exact subject; take a look at our How To Clean a Hayward AquaRite Turbo Cell guide and video
Reply
I have an Aqua Rite 20 with a t-5 cell. The software Revision is 1.4. Will this cell work as a replacement?
Reply
Hi Dave, The AquaTrol & AquaRite 20K Replacement Cell Only will be the correct replacement if you already have a T-5 Cell.
Reply
Does a t-cell 5 ever expire or do they need to be changed ?
Reply
I found this that explains the situation very well - "The cell is the part of the system that actually converts Salt (NaCl) to Chlorine. Water passes through the cell and over solid titanium plates that are coated with either ruthenium or iridium, which are naturally occurring metals. As a charge is sent to the cell from the control board and electrolysis occurs resulting in the production of chlorine. Eventually the metallic coating on the cells erodes away, requiring the cell to be replaced, but there are several factors that impact how long your cell could last. "
Reply
I currently have a GLX Turbo cell - 15 but I see on your site that it is associated with 40,000 gallon pools and that a T cell - 5 is for 20,000 gallon pools. My pool is 10,500. Shouldn't I replace my T15 with a T 5?
Reply
You could go with a smaller cell, but we always suggest going with the T-15. With a pool your size, you can run the T-15 at 35% which would be equal about 70% on a T-5.Running the cell at a lower output will make the cell life longer.
Reply
Is the GLXCell5 an exact replacement for the Mineral Springs by BioGaurd T-Cell 5 that I bought with my pool in 2009?
Reply
Hi Artie, The Turbo Cell GLXCELL5 will replace the T-Cell 5 on the Mineral Springs by BioGaurd chlorine generator.
Reply
Hello,
I installed a pool last year and the salt cell is T-CELL-5. What is the life expectancy? And if it is still good to reinstall for this summer is there any preparation or cleaning of the cell I should do before installation when I open the pool? Thanks in advance!!
Reply
Hello Jo Ellen, The life expectancy of a T-5 Cell (if matched to the correctly sized pool) will be at least 3 years, but could extend for more. You will want to inspect the inside of the cell for any debris or calcium build up, and clean it out before re-installing it. You can visit our How To Clean a Hayward AquaRite Turbo Cell if you have additional questions.
Reply
Hello, I have an Aqua Trol with a tcell5 which cracked. Can I which to a tcell3? Size of pool is under 11000gallons? My Aqua Trol is rl1.45.
Thanks
Reply
Julie, I would not recommend changing the cell to the TCELL3. I would recommend replacing it with the same cell you have now.
Reply
We have an Aqua Logic Goldline salt system from 2007. The current salt cell is a t-5 turbo cell - turbulent flo chamber. The pool is inground and 14,000 gallons. What do I replace it with? Is the t-5 only for above ground pools as I have been reading? Should I go up to a higher cell so then it will run less to extend the life of the cell?
Reply
Hi Janet, If you currently have a T-Cell 5 you can replace it with the same size cell. If you would like a larger cell you will have to make sure that your firmware is compatible with the larger cell.
Reply
I'm needing to replace my cell. Right now I have a Hayward Goldline T-CELL-5 for an above ground pool up to 20,000 gallons. Which cell should I purchase?
Reply
I need to buy a replacement AquaTrol T-CELL-5 generator because the old one I had stopped working. I found the item on your web site. Once I connect it up to my pool, and connect it up to the control panel box, is there anything else I need to do? Will the new chlorine generate automatically start working with the existing control panel box I have?
Reply
Yes, after you hook the new cell up it is supposed to start generating with the control panel.
Reply
I have a Hayward GLX-CELL-5 that needs to be replaced. Is that the only kind of cell I can buy to replace it.
Reply
You can replace it with the different AquaRite size but when installing you have to make sure to change the setting on your board otherwise it will not work.
Reply
My cell has writing on it that says the cell has to be installed in a vertical position. iv'e visited all my friends and all of their cells, which are the same model as mine, are installed horizontally. Can I do the same?
Reply
Hi, Randall. You have the RJ model so it does not require a flow switch. Your cell can not be installed horizontally.
Reply
I have an Aqua Rite XL which I believe we installed in 2009. The firmware is 1.4 and the model number is 3A0906-1058650. It needs a new cell and I don't know what type to order.
Reply
My T Cell 5 doesn't read salt content correctly. My pool supply says my level is 3200 and the read out says 2200. Won't generate now. Cleaned cell with acid/water and try to re-adjust salt level. Still no luck. Started a year or more ago where it started reading lower than the test. Is replacement cell my only option at this point?
Reply
Robert- It sounds like the cell is going back, I would take your cell to a store that can test it and have it tested twice. If it fails then obviously the cell needs to be replaced. If it passes the stores TDS meter could be faulty.
Reply
I have a splash clear collection turbulent flow chamber labeled sp-18 also says electrolytic cell my instruction booklet says aqua troll by gold line controls. Inside the salt water generator it also says use with t-cell-5 so would the part # glxcell5 be the right part to replace it with?
Reply
Hi, Tony. Yes, this is the correct replacement cell.
Reply
I have a TurboCell GLX 15w for my 17,500 gallon pool. Is there a more affordable replacement? It is about 5 years old and does not generate chlorine.
Reply
Hi, Doug. You can save on upfront cost by going with a smaller cell if your system has a software revision of 1.5 or higher.
Reply
How can I check if my cell (thurbo cell 5) is working and generate salt properly?
Reply
Hi. You can take the cell to an authorized repair center to have it check out. You can also check the cell voltage, cell amps to make that there in range.
Reply
what is the flow direction when installed vertically (18 ft. above ground - model 5)? No instruction in the replacement unit and the unit does not indicate flow direction.
Reply
Hi, Marc. The cell can be installed in any direction.
Reply
Moved in 7 years ago - salt system was already here and have never replaced cell. Now it is finally dying. All the current cell says is "Hayward Swimpure." Controller is Aquarite, software version 1.4. Pool is in-ground, 17,500 gal. What is the correct replacement cell that will be compatible?
Reply
Hi, David. Based on the software revision, your system can only use the Turbo Cell T-15 - W3T-CELL-15.
Reply
I have a Goldline Aqua Rite system with a T-cell 9. The salt level is miss reading and the cell isn't working very well. It's about 6 years old. What are my options? The pool holds 12,000 gallons. Thanks
Reply
Hi Chris, At 6 years it would definitely be time to replace your salt cell and you would need this W3TCELL9 AquaRite Replacement Cell if after replacing your cell if the issue persists then you will also need this Aquarite Main PCB Board
Reply
Hi,
Will this model replace the blue essence salt cell? Please see image attached
Thanks
Hi Sally, could you send us a photo of the complete label on the cell? To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation
Reply
Good Afternoon, Would a bad cell give a false salt reading. I checked my Aqua Trol last week and it it was at 1500 for salt I added salt and it went up to 1900, then 2400. So I added another bag to get between the 26-3200 range and it dropped back to 1900, then 1500, and now 1100. I took a water sample to the pool supply and it checked at 5200. Way too high. Checked the cell, it looks good, no scaling that I could see. Would it be a bad cell control panel? Photos are of what I am using.
Hi David, this sounds as if the cell could be failing. These cells last on average of about 2 seasons. You can have these tested at some local pool retailers for free. I would recommend starting there.
Reply
I need to purchase a new cell and your site indicates a 3 year warranty. How are warranties handled when purchasing thru your site? Are they sent back to you?
Reply
Hi Donna, for a warranty on these cells you will want to contact us if there are any issues. We first will try to troubleshoot and if seems to be defective then we would get the unit back and ship you another. Please see our warranty policy for further details.
Reply
Hello
I have an Aqua Trol (model AQ-TROL-RJ) with a failing T-Cell-5 Turbo Cell. The unit was installed in 2012 and has firmware 1.45 .
Would this unit be a compatible replacement ?
thanks
Reply
Hello Jeff. The Hayward Pool Products AquaTrol 20K Replacement Cell W3GLX-CELL-5 would be a compatible replacement for the T-Cell-5. AquaTrol & AquaRite 20K Replacement Cell Only - No Unions - W3GLX-CELL-5
Reply
I have a Hayward AQ-TROL-RJ running software version 1.45. I have been using a Blue Works salt generator for a couple of years and it appears to have quit working. I am wanting to go back to a Hayward generator but do not know what T-Cell I originally had. My pool is 13,500 gal. What is my best alternative for a new T-Cell (I understand using a larger capacity will prolong life of cell). So what size do you recommend and which cell will work with my controller?
Thank you.
Reply
Hello Glenn. The Hayward Pool Products AquaTrol 20K OEM Replacement Cell W3GLX-CELL-5 has sufficient chlorine generating capacity for your 13,500 gallon pool. This product is a Hayward Original Equipment Manufacturer (OEM) part. AquaTrol & AquaRite 20K Replacement Cell Only - No Unions - W3GLX-CELL-5
Reply
Could I use a Hayward GLX-CELL-5 Turbo Cell as a direct replacement for a Hayward BEX-CELL-20 (Blue Essence)? If so, will the cell dimensions be the same?
Reply
Hello Mark. The Hayward Pool Products AquaTrol & AquaRite 20K Replacement Cell is a compatible replacement for the Hayward BEX-Cell-20 (Blue Essence). The cell dimensions are identical.
Reply
I have an AquaTrol & AquaRite 20K - W3GLX-CELL-5 that doesn't generate chlorine anymore from salt. Can it be repaired? Where do I send it?
Reply
Good day, at this time these units can not be repaired. You would need to replace the complete cell.
Reply
I have a Hayward Goldline AQ-TROL-RJ AquaTrol Above-Ground Swimming Pool Salt Chlorination System that is about 3.5 years old on a 10,000 gallon pool. Can I use a T-3 cell (GLD-45-1009 / W3T-CELL-3) as a replacement cell? If not, why not?
Reply
Hello Robert. According to Hayward Technical Service, the only cell compatible with the Hayward Goldline AQ-TROL-RJ AquaTrol Above Ground Swimming Pool Salt Chlorination System is the AquaTrol & AquaRite 20K Cell, W3GLX-CELL-5. AquaTrol & AquaRite 20K Replacement Cell Only - No Unions - W3GLX-CELL-5 For further information, Hayward Technical Service can be contacted at 1-888-HAYWARD, following the prompts for residential Saltwater Chlorination Systems.
Reply
I have a Haywards T CELL 5 which needs replacing. The Aquarite control box I have is only version 1.45
Will the GXL CELL 5 work with version 1.45
Reply
Hello Glen. According to Hayward Technical Service, the AquaRite Main PCB software revision 1.45 is compatible with any current T-Cell replacement model. The AquaRite Main PCB software revision 1.40 is limited to the T-Cell5. Attached please find the link to SWG replacement salt cells. Replacement Pool Salt Cells
Reply
I have a Hayward blue essence salt cell system. What salt cell will work with my control box.
Reply
Good morning,You can use the direct replacement cell W3GLX-CELL-5.
Reply
