So the warm side sensor, does it need to be placed on the roof near the panels?
Reply
Hi Phillip, The Solar Sensor is to be pace near the panels so that it is exposed to the same sunlight as the panels.
Reply
The solar panels will not shift the heating light does not come on there are no sensor lights blinking the temperature gauge is set I tried raising and lowering no results and yes the sun is out thank you
Reply
Hi, Troubleshooting instructions can be found on page 5 of the Solar Pool Controller Manual.
Reply
My sensor light is on, steady red, where do I find a replacement and how much are they?
Reply
Hello Mark, I would run diagnostic with Hayward 800-657-2287 to see if there is a specific part that needs to be replaced or the unit itself. The whole unit is Goldline Controls GL235 Solar Controller w/ Actuator, Valve & Temp Sensors - GLC2PA is $369.99
Reply
Can the 2" I.D. 3-way valve be configured such that inlet is from one end and outlets are the opposite end + the side end? This would make it much easier to cut into my existing piping system.
Reply
Hi, Fred. You can use the three-way valve in the way that you've described.
Reply
I have Aqua solar gl-235 solar heat for my pool. My controller indicates that my sensor is not responding (a red indicater light is on). What problem solutions do you reccommend. Do I need to replace the sensor? If so what do you reccommend and what is the price? This seems like a job that I can do?
Reply
Hi, I would first follow the troubleshooting suggestions on page 6 of the Goldline Controls GL235 Manual and proceed with the suggested resolution.
Reply
my solar valve rotates and wont stop when I put it into Auto or on
Reply
Hi. The actuator may be wired incorrectly (check the schematic accompanying the actuator) or the toggle switch is in the incorrect position. The valve should be in the Auto position for normal operation.
Reply
Maybe a stupid question, but what are the 4 tiny clear/orange plastic pieces for in the kit? Are they wire connectors? I just don't want to be hooking it up wrong and/or cause it not to work properly.
Thank you!
Reply
Angel, The 4 orange plastic pieces are the LED indicators. They get installed inside of the control box.
Reply
I am looking for just the two temp sensors that come with this kit. Mine current ones have appeared to begin failing. Does anyone know where I could get just those parts?
Reply
Hi, Aaron. The replacement Temperature Sensors is Part # GLX-PC-12-KIT.
Reply
