My model number is SP3200DR
What motor drive do I need?
Reply
Brad, This is the correct motor drive unless your previous one included the safety vacuum release feature. If that's the case you need part # SPX3400DRVR.
Reply
which drive do I need for a Hayward sp3202vsp
Reply
Hi, Jim. This Drive Assembly is not compatible with the SP3202VSP, you will have to purchase the Power End - SPX3202Z1VSPE.
Reply
I purchased a Hayward SPX3400DRVR digital control interface, when I opened the unit there was a tag that says SP3200DRVR serial # 3VR19121-C03784, I am confused what did I receive ?
Thanks Pete
Reply
Hello, I can look into this for you. Do you have an order number I can reference this by?
Reply
I have a Hayward EcoStar SP3400VSP that dies last night with fault PUMP HAS STALLED. According to my package it came with an SP3200DR (thirty-two, not thirty-four). Is this SPX3400DR a replacement for my SP3200DR?
(Thank you to the invaluable David Van Brunt from swimmingpoollearning.com for pointing me in your direction.)
--Scott
The correct drive for this is the SPX3400DR
Reply
Does this part include the motor as well as the interface controller? Have t"stalled" SP3200DR". I am assuming due to controller chip on the board under the display. Pump is 5 years old connected in a really tight spot & want to avoid cutting pipes by slipping on new "back end" of pump and not touch pipe connections. Also are these refurbished parts or new? do you have a video for swamping this type of part? The one I found on Youtube from INYO seems to be much simpler model to repair..thanks.
Hi, Ray. This is the Drive Assembly only, the Motor Assembly - SPX3400Z1ECM is sold separately. These are new unrefurbished parts. We do not have a replacement video for this part.
Reply
How difficult to swap out the drive assembly on the sp3200dr? Will I first need to disconnect the current entire pump or can I do it in place? And would the drive resolve the "stall" issue? Again the shaft is turning freely and pump malfunction was instantaneous, that is working perfectly fine until it just stopped. Thx.
Reply
Hi, Ray. Replacing the Drive Assembly is not difficult. The drive assembly can be replaced without disassembling the pump so it can be replaced in place. The issue could be caused by a faulty drive, motor, or both.
Reply
i need a controller/display for a SP 3200. When looking for parts it often brings up 3400. are they interchangeable??
Reply
The SP3200VSP and SP3200VSPND will use Hayward TriStar VS Pump SP3200VSP Series parts page http://www.inyopools.com/parts_hayward_tristar_vs.aspx
Reply
Hello
ny SPX3400 drive no longer works, which unit would I need?
Thanks
Sadly
Phil
Good afternoon, if you have the following HAYWARD ECOSTAR PUMP SP3400VSP SERIES then this would be the correct drive for that pump.
Reply
I have a SP3400VSPVR, I am getting a Heat Sink Overheat Error, According to a diagnostic sheet I need to replace the drive... is this the correct part?
Reply
Hey Eric,Yes this the correct drive for the SP3400VSPVR Hayward pool pump
Reply