?     Asked on 12/9/2015by mike

what size pump do i need for 20x40 foot pool (36000) gallons
 Reply

A  Answered on 12/9/2015 by InyoPools Product Specialist Lennox H.

Hi Mike, This Pump can be used on a 36,000 gallon pool depending on the total feet of head of your pool. I would recommend calculation the TFH of your pool using our How To: Size a Pool Pump guide to confirm if this pump will provide at least 75 GPM based on the feet of head of your pool to achieve an 8 hour turnover rate.
 Reply


?     Asked on 6/25/2016by Bill

Existing electric line in bad shape. Connects directly to breaker box. Also wires are a bear to try to connect to screw terminals inside of motor because of small space and thick gauge of wires. I notice this motor also has tab connectors for wires too. Where do I find suitable new outdoor quality electric cable for this Jacuzzi Magnum 3/4 230/115 pump? .
 Reply

A  Answered on 6/25/2016 by InyoPools Product Specialist Alex V.

Bill, You should be able to locate suitable wiring at Home Depot or Lowe's.
 Reply


?     Asked on 10/17/2016by al

Is the motor included?
 Reply

A  Answered on 10/17/2016 by InyoPools Product Specialist Adam Y.

Al, Yes. This would be the complete pump as pictured (pump housing and motor).
 Reply


?     Asked on 7/3/2017by Inyo Visitor

is the electrical cable included with the magnum force 3/4 HP pump
 Reply

A  Answered on 7/4/2017 by InyoPools Product Specialist Alex V.

Hello, The 94027107 Jacuzzi Magnum pump does not come with a cord.   
 Reply


?     Asked on 7/8/2017by Inyo Visitor

i need to replace a pool motor plus pump. The motor is a Century Centurion and the pump is a Jacuzzi - Magnum Force. The manufactures label for the motor shows 2.0 HP, but there is also a label that shows Total HP = 2.4. Question - what actual HP do i need? Thanks
 Reply

A  Answered on 7/10/2017 by InyoPools Product Specialist Joe S.

Yes if you have a 2hp motor with a higher Service Factor then you would go with this unit. You can also go with Magnum Force V Series 2.7HP Variable Speed Pump (VMF-S2) - 94026140
 Reply


?     Asked on 4/2/2019by Inyo Visitor

concrete slab is wet under pump?
 Reply

A  Answered on 4/2/2019 by InyoPools Product Specialist Lennox H.

Hi. The pump shaft or housing seal may need to be replaced. You can purchase the Magnum Tune Up Kit - GOKIT14.
 Reply


?     Asked on 4/5/2019by Inyo Visitor

changes out the seal on jacuzzi magnum force pump. when tried to start pump it would not run, just a humming noise. in a bind? what to do?
 Reply

A  Answered on 4/6/2019 by InyoPools Product Specialist Lennox H.

Hi. Check the motor capacitors to be make sure that they're good. Use our How to Test a Pool Pump Capacitor guide.
 Reply


?     Asked on 4/5/2019by Inyo Visitor

replaced seal now pump just makes a humming sound, want start up
 Reply

A  Answered on 4/5/2019 by InyoPools Product Specialist Lennox H.

Hi. Check the motor capacitors to be make sure that they're good. Use our How to Test a Pool Pump Capacitor guide. 
 Reply


?     Asked on 4/5/2019by Inyo Visitor

when we get it running it runs counterclockwise, shouldn't it be running clockwise? plus after we get it running and stop it it binds up, what to do?
 Reply

A  Answered on 4/6/2019 by InyoPools Product Specialist Lennox H.

Hi. The motor will rotate counterclockwise looking at the motor from the shaft end. If the motor is binding, you may have the impeller on too tight.
 Reply


?     Asked on 7/8/2019by Inyo Visitor

I need to replace my Magnum 750 magnum pum 3/4 9402 7323 from around 1984 but can't seem to locate the model.
 Reply

A  Answered on 7/9/2019 by InyoPools Product Specialist Joe S.

Good afternoon, the Magnum Force Pump 3/4 HP - 94027107THIS PRODUCT IS NO LONGER AVAILABLE. I would recommend the Sta-Rite Max-E-Pro 3/4 HP Full Rate Energy Efficient - P6E6D205L.
 Reply


?     Asked on 8/14/2020by Rob Conaghan

can I replace this pump motor with V-Green 1.65 HP Round Flange 56J Variable Speed Motor ECM16CU
 Reply

A  Answered on 8/14/2020 by InyoPools Product Specialist Lennox H.

Hi, Rob. Yes, you can replace the motor of this pump with the V-Green 1.65 HP Round Flange 56J Variable Speed Motor - ECM16CU along with the Tune Up Kit Carvin/Jacuzzi Magnum Series - GOKIT14
 Reply