Housing front has a small split that is dripping ,is there a repair of sealant that can seal this or other options . thanks for your response.
Reply
Good afternoon. I have not heard of any type of sealant that will do a permanent fix. There is just too much pressure and any epoxy or resin just can not stand up to it.
Reply
Pack Fab pump housing 35-5459 is replaced by 355468 per what I see in the Q & A. So this housing has a slip connection but the diagram shows it attached to the strainer with four bolts an an "O" ring seal. Therefor I am assuming that there is no piping needed to make the connection between these two parts. Is that correct?
Thanks Jim
Reply
Hi, Jim. That is correct, this housing will mount to the strainer using bolts. The threaded description refers to the internal port if you're not using a strainer.
Reply
Hi, I'm looking for a threaded front housing, it has to fit on CFII-N1-5FE / 34-5300 CHALLENGER
Reply
