?     Asked on 8/16/2015by rich

What is diameter of plate in inches? What hose size?
 Reply

A  Answered on 8/17/2015 by InyoPools Product Specialist Bob D.

Hi Rich. The diameter is 7 3/4 " and the hose connection is 1 1/2". Here is a link to the instruction sheet.
 Reply


?     Asked on 8/8/2016by keith

I HAVE A PROBLEM WITH MY INGROUND SKIMMER BOX, SOMEONE PUT MY SKIM VAC UPSIDE DOWN AND IT HAS GOTTEN LOGGED IN THE SKIMMER HILE, HOW CAN I GE THIS OUT SO IT WILL NOT MESS UP THE SKIMMER LINE AND WOULD THIS CAUSE THE PRESSURE IN MY WALL JETS TO SLOW
 Reply

A  Answered on 8/19/2016 by InyoPools Product Specialist Stacey M.

Hello Keith, Depending on how it is stuck into the skimmer under the tile, turn off your pump and try reaching through where the weir entrance is and the other hand on the top of the skimmer and try getting a section of the Vac plate lip. Or you could back wash some of your water down below the skimmer to see if the pressure would release. Is your basket still in the skimmer?
 Reply


?     Asked on 7/23/2017by Inyo Visitor

does it have the rubber gasket?
 Reply

A  Answered on 7/26/2017 by InyoPools Product Specialist Alex V.

Hello, Yes, this does have the rubber gasket attached. 
 Reply


?     Asked on 7/25/2019by Inyo Visitor

hello I have a hayward skim vac sp1068 what is the current skim vac that matches
 Reply

A  Answered on 7/25/2019 by InyoPools Product Specialist Lennox H.

Hi. If you're looking for a vacuum plate, we will need to provide the model of your skimmer. This SkimVac Vac Plate - SP1106 is used with the following skimmer models SP1081/1082/1084.
 Reply


?     Asked on 9/20/2019by Anwar Gopalani

I have a skimmer and inside the skimmer I found a sticker with the number 08650-1403 etc. on the skimmer plate outside the number is SWIMQ WC27-92. Which vacuum plate is appropriate for me.

 Reply

A  Answered on 9/20/2019 by InyoPools Product Specialist Jessica C.

Hi Anwar. For the SwimQuip WC 27 92, the Vacuum plate you will need is the Plate, Vacuum Fits Jacuzzi Clear (08650-0042)
 Reply


?     Asked on 10/11/2019by Mark

I have an 8" Hayward skimmer plate 1 1/2" pool vacuum hose , but I need a 90 degree elbow swivel adapter for it also for the vacuum hose to fit properly in the skimmer & not be crunched up to work. Do you have such a part or a suggestion to solve this problem ? Thank You , Mark
 Reply

A  Answered on 10/11/2019 by Industry Professional

The mfgr recommends the hose exits out the top of the skimmer, over the coping and into the pool. An elbow or kink will impact the vacuum performance.
 Reply


A  Answered on 10/15/2019 by Industry Professional

It is better to go straight out the top of your skimmer so your vacuum hose is not compromised.
 Reply


A  Answered on 10/11/2019 by Industry Professional

The mfgr recommends the hose exits out the top of the skimmer, over the coping and into the pool. An elbow or kink will impact the vacuum performance. Damage to the weir door and skimmer can happen if you are exiting thru the weir door.
 Reply