I just ordered drive belts for a Aquabot classic. I just want to confirm that each order comes with (2) belts.
Reply
The Drive Belt, Tan, Small; (Single) is a single belt and is not sold as a set. The Aquabot Classic uses (2) Drive Belts.
Reply
how to replace drive belts
Reply
Hi Geraline, The How to Replace an Aquabot Classic Robotic Pool Cleaner Drive Belts provides you with the steps needed to replace this drive belt.
Reply
hi,i have a aquabot turbo industrial z 2 serial # 0816556 ,there is 2 small belts on each side.that look like the item show in this listing. it is the right one? thank you
Reply
I have an Aquabot Xtreme and I think one of my tan drive belts is missing on one side? Should there be two of them? The machine is not running the floor of the pool quite like it normally does and I think maybe one of the tan belts may have broken?
Reply
Hi, Rhonda. The Aquabot units require two Drive Belt - 3302.
Reply
Have a Millennium XE need the drive belts but do not see the model listed
Reply
Hi, Eugene. I was not able to locate a part listing for the Millennium XE so I can't confirm which drive belt is needed. I would recommend contacting Aquabot at 1-800-845-4856.
Reply
I need to install part Drive Belt, Tan, Small; (Single) - 3302, Do I need any special tools to install the belt, and what do I do to install the belt?
Reply
Hi, Gene. A Phillips screwdriver and a needle nose pliers is needed to replace these drive belts. You can refer to our How to Replace an Aquabot Classic Robotic Pool Cleaner Drive Belts for instructions.
Reply
I have an Aquabot supreme I changed both drive belts they are 5 1/2 inches they seem to lose is there another belt that smaller or is there a way to tighten them up
Reply
Hi, David. There is not another belt available or adjustments that can be done.
Reply
I have an aquabot elite ; are these the correct belts. Are your installation instructions for the elite model also ?
Reply
Yes, these are the correct belts for the Aquabot Elite RC model. We do not have any installation guides on these parts however there may be a youtube video showing this.
Reply
does the aquabot supreme drive belts only go on one side or are there 1 set on each side?
Reply
Hello Stephen. The Aquabot Supreme requires only 1 set of drive belts, a set being 2 belts. They are installed only on one side. To verify, simply remove the bottom filter housing and look inside. The pump motor will be in the center and the drive motor (or drive motors) will be on the side. One drive motor; One set of belts. According to the manufacturer the bushings should be replaced at the same time as the drive belts. The Aquabot Supreme requires 6 bushings. O.E.M Bushing .5 ID Nylon Whit for Aquabot Pool Cleaners (Single) - 2600
Reply