My aquabot junior died. I would like to get a fuse to replace to make sure the box itself is dead and not just the fuse. What kind of fuse is it? Do you sell them?
Reply
My power control box has a model number: 7176DC. Another nearby number is SP12023048. This power control box does have a fuse. Do you carry a replacement fuse for sale?
Reply
Hi, Ron. The Aqua Products Power Supply Fuse - 7101 is used with all the others, the parts diagram does not list the fuse used with this power supply.
Reply
Hi Ron.
When I switch on my power supply it puts out 48VDC after a slight pause but hen shuts down after about 5 seconds. It will not stay on. When I restart it it does the same thing every time.Any ideas?
Reply
If the power supply is over 3 years old then it may just be an old power supply that has failed. In that case you would need to replace the Aqua Products Power Supply, 120/48VDC, Double Shaft Motor, 2 PRF Socket, Internal Timer, 2PRGM. I would suggest inspecting the motor in the cleaner as well and make sure it is not defective. But, other than that I suggest contacting the manufacturer and seeing if their technicians may have any other tips.
Reply
I have Aquabot Pool rover Jr Hybrid Serial # 516IJTTX45632. Power box was accidentally trashed. Which power supply do I need please. Thanks for you assistance
Reply
Scarlett, the Aqua Products Power Supply, 120/48VDC, Double Shaft Motor, 2 PRF Socket, Internal Timer, 2PRGM is not the correct power supply for your Aquabot Pool Rover Jr Hybrid Serial # 516IJTTX45632. You would require the POWER SUPPLY, 120/36VAC, 2 PRF SOCKET, INTERNAL TIMER, 2PRGM; (Single) - 7176D.
Reply
Will the power supply put out the 48 volts without the cleaner attached?
Reply
Hi. Yes, the output volts should still be 48DC with or without the cleaner connected.
Reply
What if shuts off aster 5 seconds
Reply
I believe above answere is incorrect. I have spoken to two people who both have this power supply and when tested without cleaner attached, powers on, puts out 48 volt for a few seconds then clicks off. I think may need cleaner attached to work correctly.
Reply
I got a Aquabot hybrid rover but I need a power supply!
The plug is a 2 prong!
What power supply do I need to order?
Hello, According to the parts break down. This will be the power supply you will need.http://www.inyopools.com/Products/07801352077868.htm
Reply