Sep 5, 2021 ... The timer was about to turn off the pump, but I wanted it on a bit longer. ... I forced it and the motor shut off, just making a humming noise. I ...
May 31, 2020 ... ... shutting off. I've double checked my wiring and everything seems ... motor I uninstalled (which was installed by a local pool company).
The Thermal Overload Protector on a motor monitors both motor temperature and current. When either exceeds the motor's limit, the Protector will shut the motor off until it cools. Overheating or h...
Jul 16, 2015 ... If your motor stops cold in its tracks then it is likely overloading the circuit or tripping a thermal fuse. Both a big no-no and should be ...
Oct 2, 2017 ... I researched what I could, and replaced the timer today. Same thing, if you switch the manual on, it powers up for a bit then the pump motor ...
This guide provides an overview of the A.O. Smith motor parts that you can replace on the electrical end of your motor. This picture shows the electrical parts with the electrical cover off. Instructi...
Apr 27, 2019 ... So I wait a little bit and noticed the housing very hot, I turn it off and check the temp. with my infrared thermometer, it reaches 150 ...
This guide discusses the common problems related to a motor that runs very hot. If not corrected, a continually overheated motor will fail. Note that it is normal for a motor to run somewhat hot to th...
I have similar issue with my emerald spa. Has a waterway pump 3721621-1w5a. It starts and runs for a few seconds but then I get a load hum and the motor stops.
If your pool pump motor start to get noisy, it often means that your motor's bearing are failing and need to be replaced. If a failing bearing is not replaced promptly, the motor can overheat and ...
