Jun 30, 2022 ... Hi Brent, if everything is good (no issues with the impeller or motor shaft seal) then the bearings in the motor could be going bad which would ...
Sep 18, 2018 ... it was working and running at a good pressure but then the motor shut off and geysered water from the pool skimmer to the point it blew the lid ...
If your pool pump motor starts but shuts down unexpectedly it is probably overloaded and the thermal overload protection device has tripped. This guide discusses what to look for to correct this issue...
Aug 26, 2018 ... I have a very small pool, maybe 7500 galloons and it is consuming more of my time than I would like it to. I. have a Jandy Pump, Model No.
May 28, 2019 ... There are a few reasons why the motor could run hot and turn off. Listed below are a few guides/articles that explain what to look for.
Apr 27, 2018 ... I turned it off and waited about 10 seconds and it will work for another 3 minutes and then the Polaris stops (but the motor keep running). I ...
Dec 14, 2019 ... On power up motor is louder than usual; shaft and impeller seem to spin, but motor cuts off after several seconds. Internal motor circuit ...
Sep 16, 2021 ... (Both via Omnilogic controller) Skimmer is clear, basket is clear, backwash done, motor is cool to touch. Even took pump apart and impeller is ...
This guide discusses the common problems related to a motor that won't start or once it does start shuts off after 5 minutes.
Apr 22, 2017 ... ... turns a bit, then the overload protector kicks in and the motor shuts off. I replace both run capacitor and start capacitor and no changes ...
