$1,316.54
By Hayward Pool Products
Model # H1501
The Hayward H-Series heater represents the very latest in heating technology for swimming pools and spas. H-Series heaters are easy to install and maintain, thanks to its low profile, light weight and CPVC plumbing capabilities.
Rust resistant water path, with injection-molded polymer header, offers improved by-pass control and extended life by providing additional protection from the damaging effects of erosion from high flow conditions.
Heat exchanger reliability is improved due to the reduction of condensation hat can form on tubes. Exclusive CPVC plumbing kit allows for universal heater replacement and maximum plumbing versatility.
Our patented single header "V" baffle design heat exchangers allow for long life, fast heating and virtually no condensation. All Hayward heat exchangers are now protected with highly resilient Cupro Nickel for greater durability and longevity.
Constructed of tough, durable stainless steel, H-Series burners can be removed individually or as a complete unit for easy maintenance and cleaning.
H-Series Thermal Efficiency Rating = 83%
1 year parts and labor limited warranty for single family residential users
How do you know if a pool heater is a propane heater or a natural gas heater?
Reply
Typically in the product name we use the abbreviation of "LP" for propane or "NG" for natural gas. Click here for a full listing of our >Pool Heaters.
Reply
Will a gas heater operate at the low speed of a dual speed motor?
Reply
Probably not - Most gas heater will shut off at low GPM levels (20-40) to keep the heater cores from overheating - 20 for 200 BTUs, 40 for 400 BTUs. Depending on your pool system you might get these GPM levels at the low speed but generally these heaters must be run at the motor's high speed.
Reply
Is this Hayward heater good for an indoor application for a commercial spa 5' X 8' X 4' deep and is it adaptable with a power vent?
Reply
Do you know if your local code requires that the heater be ASME certified as some commercial code does require this certification and this heater is not ASME certified. If you do not require the ASME certification than yes this would be a great heater for you. Based on your dimensions your spa is roughly 1200 gallons and this heater will take 140 minutes to raise the body of water 30 degrees. We do sell a Hayward indoor vent which you may view at the bottom of this page (DH150). If you require an ASME heater than I would suggest the Raypak 206K ASME heater along with indoor draft hood.
Reply
Where can my heater be installed?
Reply
There are specific venting requirements and clearance distances that must be met to ensure proper operation. Consult the owner’s manual for exact specifications for your model of heater.NOTE: Gas fired heaters should be diagnosed and repaired by trained personnel.
Reply