$2,450.18
Part # LRZ400EN
With 60 years experience as the No. 1 selling brand of pool heaters – Jandy’s new Legacy Heater is designed for today’s discerning market. Available in two models, the Legacy LRZE (electronic ignition) heater features a technologically-advanced dual-thermostat control, and the LRZM (millivolt ignition) model features a single control with easy on/off switch.
Whichever model you select, it’s sure to provide years of dependable service. With our industry-leading 24-point quality check system, you can depend on Legacy’s performance and reliability year after year, season after season.
LRZE (Electronic)
LRZM (Millivolt)
The Pool Sizing Guide shows the maximum pool surface area our Legacy models will heat based on the temperature difference between the air temperature during the coldest month the pool is used and the desired pool temperature. Figures are based on average wind conditions and average pool depth.
The Spa Sizing Guide details the time required for each model to raise spa temperature by 30°F.
Replacement for Jandy Lite2™ heaters.
*ASME® Certified models available.
Will a gas heater operate at the low speed of a dual speed motor?
Reply
Probably not - Most gas heater will shut off at low GPM levels (20-40) to keep the heater cores from overheating - 20 for 200 BTUs, 40 for 400 BTUs. Depending on your pool system you might get these GPM levels at the low speed but generally these heaters must be run at the motor's high speed.
Reply
What is the difference between an Electronic and Millivolt ignition?
Reply
The basic answer is that Millivolt is the old style of ignition, using a standing pilot light. While the electronic ignition uses a spark start system like a gas grill. Electronic ignitions are more efficient in gas usage and also are better suited for high wind areas where a pilot light might get extinguished.
Reply
Hi. I am replacing a Teledyne heater for a in ground pool. The heater is indoors and is vented to the outside. I'm looking at the LRZ400EN. I understand this has the electronic ignition and not the mili volt I have now. I will have an electrician wire it. My question is about the venting and if I need a draft hood. I know I need to vent it to the outside. I had hoped to just connect to the venting that's there now. Do I need the draft hoot to be able to attach the venting to the heater?
Reply
Yes, I would recommend you sill use the mfg drafthood if you will be using this heater indoors. The correct draft hood for this model is R0499605.If you would like to consult Jandy directly, their contact # is 800-822-7933
Reply
is this a Low NOx unit ?? I live in Texas
Reply
Good morning Jerry, This unit is not a LOW Nox unit. However the high-efficiency, low-NOx JXi is available in two BTU sizes, 260K, 400K, and offered in both natural and propane gas models.
Reply
Dose my jandy pool heater burner tray need yearly servicing.?
Reply
Hi Robert, The Jandy Legacy Electronic Ignition Owner's Manual has all maintenance and service instructions for this unit. It does not list any specific servicing for the burner tray.
Reply
The Most Helpful Review
3 0
(4 out of 5 stars) Excellent Product
Reviewed By: Lori D. from Hurricane, UT ()
Pros: All good so far
We ordered the heater as a replacement for 20 year old unit and are very happy with the size, the style, and the quality of the heater. My only complaint would be that the product came with no installation instructions. However inyourpools.com does have an online manual that can be printed in PDF format.
Was this review helpful to you?
The Most Recent Reviews
2 1
(4 out of 5 stars) jandy pool heater
Reviewed By: William F. from kansas ()
Pros: delivery
Cons: none
arrived timely and intact. Hopefully will be easy to connect
Was this review helpful to you?