By Pentair Pool Products
Model # 520090
Manufacturer Code 521883
The iS4 Spa-Side Control can be used with the Pentair® IntelliTouch®, EasyTouch® Control Systems and the Compool® CP series Control Systems to provide remote switching of four control circuits from the spa location. It is typically used for activating spa circulation and three auxiliary pieces of equipment (such as lights, jet pump, air blower, etc.). One iS4 spa-side control can be installed per control system. It is possible to install two iS4 remotes on a single control system, however, the two iS4 remotes will mirror each other in functionality. The iS4 spa-side remote is a double-insulated device UL and ETL listed to UL 1563. It is splash-proof and weatherproof but should not be permanently submerged below the spa water level. The iS4 remote must be installed above the highest sustained water level.
Pentair 4-Button Spa-Side Remote Control, Voltage Rating: 5 VDC, ABS, White, Cable Length: 50 ft, 2 mA, For Use With: Pentair IntelliTouch(R), EasyTouch(R) Control Systems and the Compool(R) CP Series Control Systems
I have an old Compool spa side remote which is round with 3 push buttons, the rear fitting has a male 1 1/2" thread and screws into a wall fitting. Will this remote replace my old Compool remote?
Reply
The IS4 spa side remote is designed as a direct replacement for the older Compool 3 button spa side remote.
Reply
Is the IS4 compatible with Compool Lx3400
Reply
Hi Scott, if your LX3400 board is hooked up to a CP3400 panel it will work. The iS4 Spa-Side Control can be used with the Pentair® IntelliTouch®, EasyTouch® Control Systems and the Compool® CP series Control Systems to provide remote switching of four control circuits from the spa location.
Reply
$432.87
$496.61
$879.36
