Part # 4655-10
Manufacturer Code O-470
Dimensions 17" ID, 17/32"
Generic Replacement for Tank O-ring 18" (After 11-94) - 53008800Z
Cross-Section = 1/2"
Inside Diameter = 17-11/16"
Disclaimer:
All manufacturers’ names, brand names, trademarks, images, symbols, descriptions, and part numbers are used herein for reference purposes only.
Pentair OEM Alternate: Part # 53008800Z
My American titan stainless steel D.E. filter model # is 586090 and is 60 square ft.
Wiul this o ring fit correctly?
Reply
Hi Ted, This o-ring will fit if your unit was manufactured after November 1994. We can not tell based on the model number, if you have the serial number you can contact Pentair at 800.831.7133 to find out when the unit was manufactured and which o-ring you will need.
Reply
Will this replace the original O-ring (the largest one that separates the top and bottom halves) for My American Products Model #56629100, Serial # 001337
Reply
Hi Garren, Yes this is the proper replacement o-ring to seperate the two halves of the American Products Filter 56629100. There is also a Generic Version of this o-ring, click this link to view or purchase the Generic Quantum Filter O-Ring
Reply
i have a american titan filter system model number 5806090. i need the center large o-ring between the top and bottom stainless half's. Is this the correct o-ring
Reply
Hi Jim, so there are few American Titan series filters. Could you send us a few photos of the filter and advise of the approximate year of installation? To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation.
Reply
help,,, My KDI filter tag is wash out however i can make out the model # 584090 but no clue about the MFG date. I am looking to replace the O-ring and not sure of the correct part # I ordered one that looks too small from prior to 1994 date. item # 4655-10A. I can assume the one after 1994 is correct but I can't tell from the pic if it would be. Any one with experience that can assist? Thanks
Reply
Hi Andrew, The KDI Filter was made by American Products and is the same as American Products Titan 48sqft #58409000 in regards about getting the o-ring before or after 1994 I would suggest purchasing both and returning the one that does not fit. You just be responsible for the shipping back.
Reply
I have one of them already, looks too round. The one on there is not round but shaped. I don't know if it is because it is pressure and molded to the shape, nor can I tell id the after 1994 is the same shape. the pic online does not do it justice, Can u tell me if the 1994 and later model is not perfectly round and longer on one side. Rater hard to describe. I better pic would help me determine. Do u have one?
Reply
Hi Andrew, This o-ring is round. Many times after years of use the originally round o-ring will be mishapened. If you already tried the other o-ring then I would be fairly confident that this one would work. This is the best close-up photo of this o-ring we have - Close Up Photo of O-Ring
Reply
Thanks my o ring is fully round Your pic shows a flared or flat end. What is the model number of that one ? Ty
Reply
Hi Andrew, the o-ring on this page is the round o-ring and is not flared.
Reply
What is the thick?
Reply
Hello Johnny. The Tank O-ring 18" (After 11-94 -) - 53008800Z measures 17" ID, 17/32" cross-section diameter.
Reply