$139.66
By Waterway
Part # 3783-307
Manufacturer Code 642-4707V
************************************************
GENERAL DESCRIPTION: 9"X 9" SQUARE RETROFIT MAIN DRAIN COVER, DARK GRAY************************************************
BASIC SPECS: SCREW HOLES: 1 IN THE CENTER OF EACH SIDE 2 OF THE SIDES HAVE 3 HOLES WITH 1 IN THE CENTER SEE BELOW FOR DETAILS USAGE: APPROVED FOR FLOOR OR WALL USAGE SPECS: SPECS SHOWN ARE FOR A SINGLE UNIT FLOOR: 289 GPM @ 2.33 FPS WALL: 198 GPM @ 1.59 FPS LIFE: 7 YEARS TOTAL OPENING: 39.9 SQ INCH 186 GPM @ 1.5 FPS************************************************
DETAILED DESCRIPTION: THIS IS A 9" X 9" SQUARE REPLACEMENT COVER THIS IS AN ANTI-ENTRAPMENT RETROFIT COVER AND SCREWS THIS HAS SCREW HOLES DESIGNED TO LET IT REPLACE A WATERWAY, HAYWARD OR PENTAIR 9" X 9" SQUARE COVER THIS HAS A REGULAR GRATED SHAPE BUT THE COVER SLOPES UPWARD FROM THE OUTSIDE TOWARD THE CENTER. EACH SIDE HAS A SQUARE NOTCH AT THE BOTTOM MATERIAL: PLASTIC COVER COLOR: DARK GRAY SHAPE: SQUARE************************************************
COVER DIMENSIONS: COVER LENGTH & WIDTH: 8-13/16" (A) HEIGHT: 1" (AT THE OUTSIDE EDGE) MAXIMUM HEIGHT: 2-1/4" (AT THE CENTER OF THE COVER) (B) MAXIMUM HEIGHT ABOVE PLASTER LINE: 1-1/4" (THE COVER IS FLUSH WITH A STANDARD 1" DEEP FRAME AT THE EDGE)************************************************
SCREW HOLES: THE COVER HAS SCREWS PLACED SO THE COVER WILL MATCH THE OLDER STANDARD WATERWAY, AND THE PENTAIR AND HAYWARD OLDER AND CURRENT FRAMES THERE IS ALSO AN 11/16" DEEP NOTCH, 1/2" WIDE IN THE CENTER OF EACH SIDE THE CENTERLINE OF EACH SCREW HOLE IS 5/16" FROM THE OUTSIDE EDGE OF THE COVER FROM THE CENTERLINE OF EACH SCREW HOLE TO THE CENTERLINE OF THE SCREW HOLE ON THE OPPOSITE SIDE IS 11-3/16". SCREW HOLE PLACEMENT: TOTAL SCREW HOLES - 8 THERE IS ONE SCREW HOLE IN THE CENTER OF EACH SIDE 2 OF THE SIDES HAVE AN ADDITIONAL 2 SCREWS EACH OF THESE IS 2-7/8" FROM THE CENTER HOLE MEASURED CENTER TO CENTER************************************************
SCREWS: THERE ARE NO SCREWS INCLUDED WITH THIS COVER************************************************
MARKINGS: 640-470X V IS MOLDED INTO THE TOP OF THE COVER AT THE EDGE THE SPECS REQUIRED BY THE VGB-2008 LAW ARE ALSO MOLDED ON THE COVER
