By Carvin


Details

Top

Part # 5063-154

Manufacturer Code 94027513

Alternate Part #'s 9402-7513, 94027513, S2LR-6-S, S2LR6S

Product Description

SLR9 WITH 6 FT. CORD AND 3-PRONG GROUNDED PLUG • SINGLE SPEED • VERTICAL DISCHARGE
Patented air-cooled heat sink allows pump to run dry without damage to shaft seal. Exclusive Ring-Lok strainer allows "tool-free" access to strainer basket. Internal ribs in large strainer basket assure flow even when filled with leaves and debris.

  • 60 Hz
  • 115 Volt
  • 2 HP
  • 12.4 Amps
  • 29 lbs

Product Specifications

HP:
2 HP
Speed:
Single
Volts:
115/230 V
Amps:
16/8
Port Size:
1.5 in.
Cord Type:
6 foot/ 3 prong
Top

?     Asked on 7/10/2015by jim martin

What voltage does this pump motor need
 Reply

A  Answered on 7/10/2015 by InyoPools Product Specialist Wes B.

Hi Jim, This pump is wired only for 115v
 Reply


?     Asked on 9/3/2015by Inyo Visitor

How many speeds
 Reply

A  Answered on 9/7/2015 by InyoPools Product Specialist Lennox H.

Hi, The SLR9 2 HP Above Ground Pump Vertical Discharge (94027513) is a single speed pump.
 Reply


?     Asked on 9/25/2015by Greg gaweda

How many gallons per minute does this pump push? With 70' of 1.5" waterline
 Reply

A  Answered on 9/30/2015 by InyoPools Product Specialist Lennox H.

Hi Greg, According to the SLR Flow Chart with 70' of pipe from a single suction line the flow rate will be about 5 GPM.
 Reply


?     Asked on 3/16/2016by Inyo Visitor

I have a 2HP Jacuzzi Pump model 2MF-S2, MFG No. 94026120 with PN 8-184951-03 motor. I don't think this unit would replace it. Do you have anything that is compatible?
 Reply

A  Answered on 3/17/2016 by InyoPools Product Specialist Lennox H.

Hi, The Jacuzzi Magnum Pump 2 1/2 HP Pump would be compatible with the Jacuzzi 2MF-S2 pump.
 Reply


?     Asked on 3/19/2016by Glenn Addis

I'm looking to replace my Jacuzzi SILR6 pump and motor. The label on the motor is partially rubbed off but shows "HP3" not sure if that would be a 3 or 3/4. I'm looking at the SLR9 2 HP Above Ground Pump Vertical Discharge (94027513) to replace it. I have a 35,000 gal above ground pool the discharge height through the filter into the pool is about 3 feet the pump sits right at the edge of the pool. Would this replacement pump be adequate?
 Reply

A  Answered on 3/22/2016 by InyoPools Product Specialist Lennox H.

Hi Glenn, This pump can be used on a 35,000 gallon above ground pool. You will have to make sure that your system can support the water flow. The SLR User Guide has all the performance info.
 Reply