$171.41

Qty:

By Zodiac


Details

Top

Part # 6204-208

Manufacturer Code R0456500

Alternate Part #'s R0456500, 47-295-1172, JNDR0456500, LAR-151-4809

Product Description

LRZE/LRZM/LXi Temperature Sensor Kit -  R0456500

Includes sleeve and gasket

Top

?     Asked on 6/29/2016by Marney

replaced this part (R0456500) less than one year ago, now the same problem has shown up again, sensor reports water temperature is 116 degrees when it is not, so heater will not go on. Bad part again, or something else?
 Reply

A  Answered on 7/7/2016 by InyoPools Product Specialist Lennox H.

Hi Marney, The temperature sensor could be bad, the only way to be sure it to troubleshoot the unit with Zodiac or replace the sensor.
 Reply


?     Asked on 11/10/2018by Jan Kouri

Model LXI400P Pool Heater Serial #B08LD0867. With the spa and spa heater running, the panel on the heater readout shows water temperature is 102F. Temperature set at 102F. All would be fine if that were the case. Realty is that the spa is actually 87F and pool equipment says the same 87F. Do I need to replace the temp sensor? If so, can you give me the part #? Or, is there a different problem.
 Reply

A  Answered on 11/30/2018 by InyoPools Product Specialist Joe S.

Good morning, yes the Lxi Temp Sensor W/sleeve & Gasket (r0456500) would be the correct part.
 Reply


?     Asked on 6/17/2019by John G

It appears I have the same problem. The controller on my LRZ pool heater is reading the current temp at 108 deg. The water is not 108. It's probably at 75 deg, I need it at 87. So the heater doesn't turn on. If I purchase this part (R0456500) - will it come with directions on how to swap out the old part with the new part??
 Reply

A  Answered on 10/1/2019 by Industry Professional

There are no instructions included by the manufacturer with this part.
 Reply


?     Asked on 12/17/2019by Mike

Jandy Legacy model LRX400en pool and spa heater shows "Fault-shorted H2O sensor." Where is this sensor and what is the part no. and approximate cost? Thank you for your kind consideration.
 Reply

A  Answered on 12/17/2019 by InyoPools Product Specialist Lennox H.

Hi, Mike. This is the correct Temperature Sensor for the Jandy Legacy heater. The Sensor is located on the left side of the manifold assembly as illustrated as Key # 15 on the Jandy Legacy Model Parts Diagram.
 Reply


?     Asked on 9/7/2021by Mark Robertson

I have a Jandy LRZ pool heater is the correct temp sensor for it?
 Reply

A  Answered on 10/13/2021 by InyoPools Product Specialist Craig C.

Hello Mark.  According to Jandy/Zodiac Technical Service, the Temperature Sensor Kit R0456500 is compatible with the Jandy Legacy Model LRZ gas heater.  Temperature Sensor Kit - R0456500
 Reply


Top

Review Summary

 (Average 4.5  out of 5 stars)
2 Rating
5 star:
 
(1)
4 star:
 
(1)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)