My back plate is in perfect condition with exception to the 2 brass female threaded inserted are missing. They are needed for screwing the defuser to it. Instead of buying a new back plate can I just use long stainless steel screws and threading it into the composite material of the back plate? Or can just not use screws?
Reply
I wouldn't screw into the material it may crack and leak. The diffuser just needs to be held in. If you still have screw holes that are staggered it will be fine.
Reply
I have a jandy jhpu pump assembly i cannot get a new base because they are no longer available.Can i use my existing motor on a new pump shpf assembly
Reply
Those two pump models have motors with different frame sizes, one being round flange and the other being square flange, so it will not work.
Reply
Does the Backplate Kit come with the shaft seal and the o-ring as shown in the picture? There is no description in the "details" section. Thanks
Reply
My SHPM1.5 pump started leaking near the backplate and the electric motor. I assume it is the two shaft seals. Would I be correct most likely?
Reply
Most commonly this does describe a shaft seal failure. Especially if the leak is specifically coming from the back of the plate where the shaft seal is located. You may want to double check the plate for any hairline cracks as well.
Reply
Jandy Stealth Pump, Model# JHPU1.5
There is a crack on the Backplate of the pump (Model# JHPU1.5).
But the photo of your part# R0445200 does NOT look exactly to the one in my pump.
(I ordered a service kit of "Tune Up Kit Jandy JHP + JHPU Series Pump", item# "GOKIT77"). The Gasket does fit).
Need some recommendation from you on the Backplate.
Thanks.
Mr. Zhengda Pang
(925) 518-8818 M
Email: zhengda.pang@sbcglobal.net
Hi Zhengda, Here is a link to the Parts Breakdown to your Jandy JHPU Pump I believe you will need Key #2 which can be found here Jandy JHPU Mounting Bracket
Reply
The two screws which go through the Diffuser and into the Backplate have come out and can't be screwed back in due to the nuts in the backplate having rusted. Can those nuts be replace or do I have to get the entire backplate?
Reply
Hello Stephen. There is no repair for the Backplate brass inserts that are used to secure the diffuser. The Backplate would need to be replaced. The Backplate Kit R0445200 would provide the necessary parts to complete this repair.
Reply
Will this fit the following pump?
Model# PHPM1.0
Serial# L07FE4279
HP 1.0
Reply
Hello Robbie. The Jandy Pump Backplate Kit - R0445200 is compatible with the Jandy PlusHP model PHPM1.0. Attached please find the Jandy PlusHP PHPM & PHPF Series Pump (2006-Current) exploded parts diagram for reference.
Reply
Will this Backplate kit fit a Jandy Stealth Model SHPF2.0 Serial R08FK1386?
Thanks
Patrick
Reply
Hello Patrick, yes this back plate is compatible with your Jandy Stealth pump model SHPM. I have also emailed you an estimate that you can convert to an order if you would like. Item is currently in stock and ready to ship.
Reply
