When I put the spa heater on it includes the pool..How to I get just te spa to heat up
Reply
Ultimately it will depend on how your swimming pool system is set up and plumbed. I would advise to either email us images of your complete pool system plumbing with lines labeled at upload@inyopools.com or have a locally licensed pool technician come review then explain your system to you.
Reply
I currently have the EasyTouch pool and spa control system indoor control panel, can I also use the EasyTouch wireless control panel outside or is it one or the other?
Reply
Hi, Ron. You can only use one or the other.
Reply
is P/N 520692 a good replacement for P/N 520306?
Reply
Hi. Unfortunately, it will not. P/N 520306 is used with the IntelliTouch and 520692 is used with the EasyTouch. They're two different controllers.
Reply
Is this a good substitute for model 520546.
Reply
if you need a whole kit replacement, then you can go with another EasyTouch Wireless Controller Kit - 4 Function - 520546. Or, if you want just the remote, the part is the Easytouch Remote 4 Aux - 520691.
Reply
My 4249A-EZHNDHLD remote broke. Looks just like this but then numbers don’t match. Will it work?
Reply
Hi. The info provided is the IC ID # that is used for these types of wireless remote. We will need to know the controller model in order to confirm.
Reply
I have a easy touch 520681 and I believe it is a intel I think it is bad I replaced the motherboard and that did not help. The pool does not do what the remote is set for. I assume it is the remote
what repote do I order I have 520681 it looks just like 520692. Are they the same and if not what do I order to replace mine 520681?
Reply
how do you set the values to heat only the spa?
Reply
Heating the spa water on demand is easy, just press the SPA button to switch the heater on and display the current temperature settings on the EasyTouch Indoor Control Panel. “Heater” will be displayed on the screen when the heater is active. The heater is active when the set temperature is higher than the water temperature. The heater will switch off when the water temperature rises above the set temperature. For more information about the spa manual heating “MAN HEAT” feature, see page 34. Pressing the Spa button will switch the filter pump on and rotate the spa valve actuator to isolate and circulate the spa water from the pool water. http://images.inyopools.com/cloud/documents/easytouch-4-and-8-installation-users-guide.pdf
Reply
We have this exact remote control. The spring next to one of the batteries fell off. Is there a part we can order or do we need to replace the whole control?
Reply
Hi, Pam. There is not a part that can be ordered from us to repair the unit. It will have to be replaced or repaired by a third party.
Reply
I have the Easy Touch 8 aux that is not wireless, pictured below. Can I just swap out the front plate to attach the wireless Remote 8 aux device, or do I need to run new wires or do anything more complicated than replacing the wall plate and setting up the wireless 8 device?
Hi, Steven. You will need to replace the wired version with the wireless remote. You will also need to make sure that the Main PCB has the proper software revision.
Reply
I need to replace my easy touch hand remote- the panel is unreadable due to a black spot. Your replacement looks exactly like mine but my IC code is a little different. Mine is 4249A-EZHNDHLD. Are they interchangeable?
Hi Susan, the EasyTouch Indoor Controller - 4 Function - 520548 is the correct replacement for your P4HEASYTOUCH.
Reply
