I have a built in pool with a 1 hp motor, I need a new motor so should I get a 1.5 to get more pressure and more out of returns?
Reply
Hi. In some cases, you can increase the pump hp by replacing the motor, impeller, diffuser. You would first have to find out if your system is able to handle the increased water flow.
Reply
Hi I have a Reliant p2410 1 hp motor that sounds like it is failing. Would this be a good replacement?
Reply
Hi, James Hays. This motor will not fit the Reliant P2410 pump. We do not carry a motor that is compatible.
Reply
will this fit a Hayward pump?
Reply
This will depend on the specific Hayward pump model that you have but if you have a Hayward above pool pump that is 1.5 hp then it likely would work. You can always call in and provide your current motor model, or part number if you would like to confirm.
Reply
Will this motor work for a replacement for a Stark USA variable speed 1.5hp pool pump?
Reply
Hi, Michael. You will need to provide us the specific Stark USA Pump model in order for us to confirm.
Reply
WILL THIS MOTOR WORK ON A SPLAPOOL MODEL #72743NC 1.5HP PUMP? AND WHAT SHAFT SEAL DO I NEED?
Reply
Could you send us a few photos of your pump and motor? Please take a close up shot of the motor label as well as a wide shot of the complete pump to include the pipes going in and out of the pump. To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation.
Reply
Did this model work on the SPLAPOOL MODEL #72743NC? I have the same motor and want a replacement.
Reply
The 72743 confirms 1.0HP http://www.inyopools.com/Products/00100018074612.htm The 1 H.P 115V Thru Bolt Motor No Base W/ Cord - PL1131 is the motor the Pump Shaft Seal PS-3867 will need to be replaced when changing the motor.
Reply
Is this motor good for an inground pool approximately 30,000 gallons
Reply
Hi Larry, so there are a few variables to consider when sizing an inground pool pump. Here is a guide that we put together called "How to Size a Pool Pump for Your In-Ground Pool" that should help with that.
Reply
What motor is recommended as this replacement?
Reply
Hi Pam, a compatible replacement motor for this motor is the BN35V1. When replacing a pool motor we do suggest a Seal Kit. Could you send us a few photos of your pump so we can suggest the proper seal kit? If so then please take a wide shot of the complete pump to include the pipes going in and out of the pump. To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation for your seal kit.
Reply
how do you get the pump housing off the motor?
Reply
Hello Rob. Attached please find a brief tutorial on the subject - Replacing an Above Ground Pool Pump Motor. How to Replace an Above Ground Pool Pump Motor If the tutorial is not of assistance, please provide several pictures of the pump inclusive of the intake and discharge plumbing and a recommendation can be made.
Reply
I have a PL 1601 pump and with the PL1135 motor, what is the correct seals #?
Reply
Hi Rob, the PSR-200 Shaft Seal is recommended for freshwater pools and the Heavy Duty - PS-3867 shaft seal is recommended for saltwater pools.
Reply
