Part # 4040-21
Manufacturer Code SPX1082D
Dimensions 8-1/2" x 3/16"
INYO # 4040-21 HAYWARD # SPX1082D THIS IS THE RING THAT THE SUPPORTS THE BASKET IN THE HAYWARD SP1082 AND RELATED SKIMMERS THIS IS A ROUND PLASTIC RING WITH A SLIGHT RECESS ON THE INSIDE EDGE OF THE RING OUTSIDE DIAMETER: 8-9/16" INSIDE DIAMETER: 6-13/16" THE RECESS EXTENDS FROM THE INSIDE DIAMETER ABOUT 3/16" TOWARD THE OUTSIDE EDGE THE OUTSIDE DIAMETER OF THE RECESS IS 7-3/16"
I have a ester Williams above ground pool it is 14 years old I need the ring basket support for my skimmer basket is this the right one
Reply
Hi Everett, You would require this Hayward SP091ES Ring Basket Support Part # SPX1096A2
Reply
How do you install a new basket support ring? Old one broke and bought the spx1082d for our sp1082 skimmer from 1989. Ring can't be installed from the top. Does the skimmer need to be removed or can it be inserted somehow?
Reply
I installed a new ring through the intake door/port from the pool. Depressed the flapper and inserted the ring from that side.
Reply
Hi Dana,
The new support ring can be installed by slipping it through the throat of the skimmer, or from the opening from inside the pool. It has to go in on an angle to start and will sit flat once you get it where it is supposed to sit.
Reply
My skimmer support ring is cracked 1/2 of the way around. Could the crack be the cause of a loss in flow with the skimmer Itself or is it merely to hold the basket in place and not overly important to fix if it’s still holding the basket in place? Secondly how would I go about fixing it if I have to? I assume since the original is glued down somehow I would need to drain the pool down and attach a new one using what kind of adhesive product?
Reply
Hi, Christina. This ring is used primarily to hold the basket in place, it will not reduce suction loss. Once installed no adhesive is required.The ring is installed through the mouth of the skimmer.
Reply
My basket support ring is broken half way but the remaining half is glued in place. Any idea on how I can remove it?
Reply
Hi, HC. I would recommend using like a putty knife to remove the broken piece that is glued in.
Reply
My broken ring has the number SP1075-E stamped on it. This ring has a round notch on the back and it snaps in place on the skimmer. The replacement suggested is the SPX1082D it is smooth and has no notches or any way to secure it in the skimmer itself.... Help?
Reply
The ring just sits in place & the basket goes thru the middle & the basket lip will sit on the ring while water & gravity hold in place. The original is in fact No Longer Available.
Reply
The Most Recent Reviews
(5 out of 5 stars) Perfect fit
Reviewed By: Inyo Customer ()
Perfect for keeping basket in correct elevation. Fast delivery.
Was this review helpful to you?