Part # 4702-13
Manufacturer Code SPX0740D
Dimensions 6" L x 6" W x 0.2" D
USED ON HAYWARD SP740-DE 2" VALVE 3 SPOKE GASKET ..... DIMENSIONS OUTSIDE DIAMETER: 5-7/8" CENTER HOLE INSIDE DIAMETER: 1-1/16" THICKNESS: 3/16" (TOP TO BOTTOM) SPOKE THICKNESS: 3/16" (SIDE TO SIDE) OUTSIDE RING THICKNESS: 3/16" (SIDE TO SIDE)
Will this fit Hayward valve stem; SP-740-C? That number was off the part. Looks right!
Reply
Hi Roy. Yes, the Valve Seat Gasket - SPX0740D 4702-13 will work with your Selecta-Flo MPV 2" (D.E.) - SP0740DE.
Reply
When I take the top of the valve off, the gasket is glued to the top piece and not the base like in the video. When I replace it do I glue it to the base or the upper piece "SPX0740C Key/Stem Assembly"? What type of glue should be used?
Reply
Hello. The Valve Seat Gasket for the Hayward DE Vari-Flo Valve model SP-740DE is attached to the Key/Stem Assembly. The replacement Valve Seat gasket should be installed in the same manner. A recommended glue for this application is the Adhesive E6000. Adhesive For Valve Seat Gasket - 81731 Please note; Prior to installing the new valve seat gasket, the surface must be clean of all old gasket material, adhesive, dirt, and oil. After installing the new valve seat gasket with sufficient time given for the adhesive to dry, lubricate the face of the valve seat gasket with a Teflon or silicone-based lubricant.
Reply
Less than 1 hr
Screwdriver
2 1
Simple repair.
0-Turn of the pump
1-Unscrew the 8 bolts in the 4-way valve
2-Remove gasket. It may be glued so try to remove it in one piece.
3-Clean the surface where the gasket is to be placed and make sure the surface is dry.
4-Add glue to the gasket and install the gasket in the valve. Ensure the gasket is press into the groves and let it sit for an hour.
5-Add lubricant to the gasket before you install the valve.
6-Tighten all screws back to the valve.
7-Start the pump.
8-You are done.
The Most Recent Reviews
(5 out of 5 stars)
Reviewed By: Inyo Customer ()
perfect
Was this review helpful to you?
(5 out of 5 stars) Gasket fit perfectly
Reviewed By: Inyo Customer ()
It fit perfectly. Very easy to replace
Was this review helpful to you?
(5 out of 5 stars)
Reviewed By: Gary B. ()
Needed the gasket when I replaced the diverter on the Hayward filter-it is OEM and perfect fit. Used the recommended silicone adhesive , let it cure 24 hours as directed and assembled. No leaks!
Was this review helpful to you?