$148.02
Part # 39258207K
Manufacturer Code 39258207R
Dimensions 10" L x 10" W x 7.5" D
THIS IS A JACUZZI TOP MOUNT VALVE, DVK-5 INCLUDES: (1) 4727- BACK MOUNT PRESSURE GAUGE (6) 4626-02 BOLT, VALVE TO FILTER (1) 4631-14 GASKET, VALVE TO FILTER (1) VALVE ITSELF ........ TOP MOUNT VALVE, BOLTS ON WITH 6 BOLTS BOTTOM FLANGE DIAMETER: 7-1/2" ........ VALVE POSITIONS (CLOCKWISE FROM TOP) STARTING ABOVE THE WASTE PORT BACKWASH, DRAIN, FILTER, WHIRLPOOL, WINTERIZE ........ ALL PORTS ARE 1-1/2" MPT, ARRANGED AS FOLLOWS 1ST SIDE - WASTE PORT 2ND SIDE - PUMP PORT 3RD SIDE - RETURN PORT
have a constant leak out of waste discharge line,\backwash. . when on filter setting, what part should i replace ? water diverter or can i install in-line ball valve to stop the leak without damaging any other part of the filter ?
Reply
Hi Ken, We would suggest replacing the diverter as this is a sign of a bad diverter and spider gasket and could be causing issues elsewhere. Do you know which model filter you have?
Reply
Do you have a replacement dial for Jacuzzi Laser250-6/A sand filter, Jacuzzi Model 9408-6030?
Reply
Hi Nancy, Yes the Jacuzzi Laser L250-7C would be the replacement for your Jacuzzi Laser250-6/A sand filter.
Reply
The Most Helpful Review
2 0
(3 out of 5 stars) Sketchy quality
Reviewed By: Kevin W. from Central Illinois ()
Pros: Ease of purchase, and timely shipping
Cons: Poor quality
I received the valve in less than a week which was great. Once opening the box and inspecting I found the gauge housing was cracked. I needed to get my pool up and running so I let that slide. Once everything was installed and running, the white piece that came installed in the valve was leaking. Not a happy camper at that point. I didn't have a big enough wrench to try and tighten. So after a days delay I got a wrench and tried to tighten the fitting. Little to my knowledge, the fitting was glued in, so off it came with a cracking sound. Back to google I went for more advise. I then had to purchase some PVC primer and cement to correct the faulty factory equipment. After letting the glue cure for 24 hours, I was finally able to run the pump with the new valve. So far it has held... Good luck Chuck.
Was this review helpful to you?
The Most Recent Reviews
1 0
(5 out of 5 stars)
Reviewed By: Jerry J. from Navarre, FL ()
Great product but even greater service. Many of us still have older pool equipment but just aren't quite ready tp spend the money on upgrade. I was able to get the right part at the right price---quick
Was this review helpful to you?