Can you buy just the spider gasket?
Reply
Hello Doug, Yes the spider gasket is available by itself. It is called the Diverted Gasket (271148)
Reply
Hello,
I have a Praher Multiport Valve that is leaking some water to the waste port when running on recirc or filter. It says SM-20 on it but when I tried to find a repair kit I noticed there are different version like SM-20-2 and SM-20-3. I am not sure which one mine is. I am guessing I need APCK1069S. Could you please help clarify?
Thanks.
Reply
Yes this kit would be the correct tune up kit for either the SM-20, SM-20-2 or SM-20-3.
Reply
I do not see the spring in the picture of the items. Does this kit include the spring for the handle?
Reply
Hello Nick, If you look closely at the picture for the APCK1069S PacFab Multiport Valve 2" w/Spring O-Ring Kit, the spring is in the middle of all those o-rings, it is included in this kit.
Reply
Is an install manual or directions included and is adhesive needed to secure gaskets?
Reply
Hi, An installation manual or directions is not included with this item. You will need an adhesive to secure the gasket.
Reply
Will this kit fit a Sta-rite WC212-150PN Multiport valve, and is this all I need to repair it leaking out of the top of the assembly?
Reply
Hi Ed, This kit does not work with the WC212-150PN Multiport valve, however we do carry all the Parts for the WC212-150PN Multiport valve here.
Reply
Does this fit a model 293.
Reply
Hi, I was not able to locate a valve with model # 293 that this kit can be used with. If you can provide more info on the valve I can confirm if this kit can be used.
Reply
I have an old Praher SM20-3 Sand Filter. I'm having trouble with the spider gasket pulling out of the base in the middle of the "spokes" between the outside and inside rings, causing water to run out of the waste pipe even when the valve is in filter mode. Is the replacement spider gasket you have semi-rigid, helping it to sty in place? If it is not, what is the best adhesive to keep it from pulling out? Is the silicone packet for lubricating the gasket and valve base?
Reply
Yes, this is the correct kit for your valve. The spider gasket needing to be replaced is what is causing that leak. You would want to use clear rtv silicone in the channels where the gasket sits.
Reply
Is there detailed instructions which show where all the parts of this kit belong in the valve?
Reply
Hi, Jay. All we have is the Pentair - Praher 2" TM22 & SM20 Part Diagram which shows you depending on the model of the valve you have.
Reply
Does this kit work with PacFab Model TM-22? I am in need of the spring kit. Does this kit include the glue or is that separate?
Reply
Hi, Im trying to figure out if this O-ring kit is what i need to replace the spider valve, and other upper gaskets for my Pentair valve on a triton II sand filter. Valve model sm-20-3, assembly model sm2-pp3.
Hi Johnny B., Yes, this O-ring Kit is the correct kit for the SM-20-3 valve.
Reply
Hi,
does this spider gasket fits the SM20-3?
Reply
Yes, the APCK1069S is the correct gasket kit with spring for the Pentair - Praher 2" TM-22 & SM-20
Reply
Thanks...
Reply
Need to rebuild an SM2-HPx62S. Box notes as 2” multi port valve, Hayward piping slip. Everything I find says it’s Praher valve due to model number. What rebuild kit is appropriate? Thanks for help. Russ
Hi Russ, For the valve in your photo we would suggest the E-50-S2B Upper Handle Assembly and this Spider Gasket E-12-S2
Reply