I have a Baquapure Workhorse super flow pool pump by Waterway 2HP 2-speed. Model PB2200-6PP, Part # SD-20-2N11CC S/N: 0912093016. Is this pump rated 115V and is a good replacement and will this new pump fit my filter system?
Reply
when you say rotating the "wet end" can you better describe the procedure. Does the base rotate or just the connector?
Reply
Hi Robert. Here's a guide on how to rotate the discharge port on a similar motor - "How To Rotate the discharge port on your Hayward Matrix Pump". The procedure should be similar for your motor.
Reply
Does this come with the electrical cord? If so how long?
Everything in the picture is included (trap, plump, motor)?
This can replace Waterway Model #SD-20-2N11CD?
Reply
Hello, this pump has a higher horsepower than the pump you currently have. I would recommend getting the direct replacement for your current pump which is part # 342061010.
Reply
I have a Waterway Hi Flo 2.0 HP, 2 speed, 115 volt, side discharge motor that I need replacing. The model I have is SD-20-2N11MD (Part # 3420610-2014). I did not see that exact match, what motor will replace this one?
Reply
Hi Mike, the Waterway Hi Flo pump uses a SPL HP rating, the 2 HP SPL is equivalent to a standard 1.5 HP motor. We would suggest the 1.5 HP Standard HP 2 Speed Motor for your Waterway Pump SD-20-2N11MD (Part # 3420610-2014). Also when replacing your motor we would suggest you replace your shaft seal with this Waterway Hi Flo Shaft Seal
Reply
all photos of the Waterway 2 HP above ground pool pump motor reflect a center discharge. Can the volute housing be rotated to the right? If so, how do I rotate it?
Reply
Hi, Tom. The discharge on this pump can be rotated, our How To Rotate the discharge port on your pump guide has the proper step you can follow.
Reply
What speed is considered normal, Hi or low? On low pressure it does not seem good enough.
Reply
Hi Ron, high speed is typically associated with regular speed. PSI and flow will indeed be lower at the low speed and will take more hours in order to turn the pool water over.
Reply
I HAVE A LEAK AT THE SHAFT OF THE MOTOR THAT GOES TO THE PUMP AND WHEN I TURN IT ON THE SHAFT DOES NOT MOVE. WHAT DO I DO???
Reply
Could you send us a few photos of your pump and motor? Please take a close up shot of the motor label as well as a wide shot of the complete pump to include the pipes going in and out of the pump. To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation.
Reply
what is the replacement for the Waterway Champs 225?
Reply
Hello Billy. A compatible replacement for the Waterway Champion 2.5 Max Rate 2-SPD Pump model CHAMPS225 is the Waterway Power Defender 270 Variable Speed Pool Pump. Please note, the Waterway power Defender has a voltage requirement of 230Volts. If the power source s limited to 115Volts, then the Pentair SuperFlo VS 1.5HP is a compatible replacement. Please note, the SuperFlo is a Full Rate Pump with a total horsepower of 2.21 and can operate at 115 and 220 volts.
Reply