I just need the lid cover, can you not sell them separate from the whole Cartridge filter?
Reply
We do sell the lid cover for the Waterway PCCF-125 here http://www.inyopools.com/Products/07501352049907.htm If you have any further questions please feel free to reply to this
Reply
What is the proper cartridge filter for the PCCF-125?
Reply
Jim, The replacement cartridge for the Waterway Proclean PCCF-125 is Proclean 125 Sq.Ft OEM Cartridge and Proclean 125 Sq.Ft. Generic Cartridge.
Reply
I'm having a hard time putting the cover back on the filter. I line everything up as directed but water still leaks out. I'm at my whits end as to what I should do.
Reply
Hello Alicia, My option would be to replace the lid o-ring as over time it becomes larger and causes the top lid and bottom base to not seal properly. The part number for the replacement o-ring is (4744-012).
Reply
I have a waterway Sierra FC100 and need to replace filter , model cp63062 according to your website this filter is no longer used why not and why was it dropped
Reply
Hi Charlie, You can still get replacement parts but that line was replaced with the Waterway Pro-Clean line.
Reply
I have this Waterway Pro-clean filter and there is a small amount of water slowly dripping from the middle where the two pieces lock together by turning. Is there a gasket that should be replaced? What is the part number? Thank you for your help.
Reply
HI Mike, You would need to replace the Lid O-ring (805-0448) to stop the filter from leaking.
Reply
There is a leak in the area of the water diverter, shown as #5 in the replacement parts section, page 8. How can this easily be repaired. Water spurts from this area.
Reply
Hi Del, It would all depends on how your unit was plumbed in, but it's not difficult to replace the diverter.
Reply
I need a 2" x 1 1/2 MPT union fitting. Also I need to
Reply
Hi Mary, The Hayward Union - SP14953S will work as a 2" x 1 1/2 MPT union as needed.
Reply
why would this filter make noise?
Like lots air flow in the filter. no air comes out air relief valve.
Reply
Hi. Your system may have an air leak causing air to enter into the system. The filter is the only equipment that is equipped to remove the air from your system.
Reply
Is there a way to plumb this system so that the return line can be valved off and used as a backwash system instead of taking the filter apart?
Reply
Hi, John. You can install a diverter valve so that you can drain water out of the pool, however, not to backwash the filter.
Reply
P#, cost, and availability please?
Reply
The Jandy Gray 3 Way Valve 1 1/2 Inside / 2 Outside - 1154 http://www.inyopools.com/Products/02601281000139.htm will be installed in the plumbing lines on the outlet side of the filter.
Reply
