Will this impeller fit a PB625 motor?
Reply
Yes, this impeller will fit a B625 Motor if it installed on a PB460 Booster Pump.
Reply
What causes an impeller to go bad?
Reply
Impellers can fail due to debris, striking its face or improper water chemistry. If your pool has sustained high chlorine levels it may deteriorate the impeller's plastic; this is commonly seen in a pump when the pool owner uses their pump or skimmer basket to hold chlorine tablets.
Reply
Will this impeller fit a Polaris PB4-60 booster pump made in 2018?
The correct impeller for your PB460 made in 2018 is the Impeller for PB4-60 - R0536400Unfortunately due to the Texas Freeze this impeller is out of stock at the moment. We are expecting a new shipment at the end of May.
Reply
i need an impeller for a Polaris PB4-60 (PB070617203) Model- 173840XCN. What is the part number/ which one do i need?
Reply
Hi, If your pump is from 2011 and earlier then this is the impeller you will require. If your pump is after 2011 then you will require this After 2011 PB460 Impeller
Reply
Will this work on:
CAT B625
Part# 7-173840-23
We will need to know the manufacturer and model of your pool pump. The impeller is not dependant on your motor, but rather your full pump. Please let me know what pool pump you are putting this motor on :)
Reply
would this fit my Polaris booster pump:N56CZ frame, part # 0-173840-23 ?
Serial 32718CH
Reply
Hello Armin. Attached please find exploded parts diagrams for the Polaris Booster Pump PB4-60 manufactured 2011 - Current and those manufactured 1994-2011. Polaris Booster Pump PB4-60 (2011-Current) Polaris Booster Pump PB4-60 (1994-2011) A quick visual comparison of the volute (wet end), note the difference in the ridges extending from the center hole, curved vs straight, will determine the year of manufacture of your Booster Pump. Impeller R0536400 is compatible for years 2011-Current. Impeller for PB4-60 - R0536400 Impeller 3262-03 is compatible for the years 1994 - 2011. The information provided does not allow for conclusive pump identification.
Reply
Thanks Craig. Seems like I have a newer model made after 2011. So would you have the proper Impeller in stock?
Reply
Yes, the Impeller for PB4-60 - R0536400 is back in stock. The Pump Shaft Seal 3/4" - R0445500 will need to be replaced, if you use the old one it will leak. We also recommend the Lubricant 1CC Pillow Pack - LUBE-PP when replacing the pump seal.
Reply